User manual PHILIPS AJ3600-00C

[. . . ] AC power failure or when changing batteries. The complete clock radio and backlight illumination will be switched off. If power supply returns after 3 minutes and the display shows: · clock time blinking - indicates you need to re-adjust the clock time. BATTERY LOW MODE indicates batteries low. Replace with fresh batteries to ensure all the features on your set will function properly. [. . . ] SETTING THE CLOCK The time is displayed using the 24-hour clock. Press SET TIME to enter the clock setting mode. Hold down or press HOUR + or MINUTE + repeatedly to set and adjust the hours and minutes respectively. Release HOUR + or MINUTE + when you have reached the correct setting. RADIO 1 Press RADIO ON/OFF once to switch on the radio. TM Display shows the radio frequency of the last selected waveband briefly before returning to the clock time. Your preset station is also shown if you are listening to a preset. (See 4) 2 Press BAND if you wish to change waveband. Helpful hints: ­ In standby clock time, to view the current radio frequency, · Press RADIO ON/OFF once or more; · For preset stations, press the respective PRESET button (1-5) once or repeatedly. TUNING TO RADIO STATONS Automatic tuning · Press TUNING +/- one second or more to tune to your station. TMThe radio automatically tunes to a station of sufficient reception. Manual tuning · Press TUNING +/- briefly or repeatedly until you reach the desired frequency. Helpful hints: ­ If you have selected AL 1 (AL ), make sure you have properly tuned to a station before turning off the set. ­ If you set and activate the same time for both alarms, only the AL 2 (AL ) will be activate at the set time. ­ When both AL 1 (AL ) and AL 2 (AL ) are turned on, by default the display shows the alarm time nearest to activation. ­ To check the alarm time setting for AL 1 or AL 2, press AL 1 or AL 2 button. ­ It is not possible to adjust the alarm time during an alarm call or the repeat alarm mode. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24-hour ALARM RESET will be automatically selected after 59 minutes from the time your alarm first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Press ALARM RESET / SLEEP. TM You will hear a beep tone confirming 24 hour reset activation. [. . . ] Please observe local regulations on the disposal of packing materials and old equipment. 1 2 3 4. 5. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. [. . . ]