User manual PHILIPS AJ3720-00S

[. . . ] Check if the mains supply, as shown on the type plate inside the battery compartment, corresponds to your local mains supply. A voltage selector - found on the back of the set · A frequency selector - inside the battery compartment adjust these selectors to match with your local mains supply and frequency. Connect the mains plug into the wall socket. The mains supply is now switched on and the numbers on the display will start to flash. [. . . ] To disconnect the set from the mains supply completely, withdraw the mains plug from the wall socket. 3W POWER BREAKDOWN BACKUP When a power failure occurs the complete clock radio will be switched off. When the mains supply returns, the numbers on the display will start to flash and you will need to reset the correct time on the clock. To retain the clock time and the set alarm time in the event of an AC mains failure or disconnection, insert a 9 volt battery, type 6F22 (not supplied) into the battery compartment: this will act as a mains backup. However, the time will not be illuminated on the clock display. As soon as the mains supply returns, the display will indicate the correct time. Replace the battery once a year, or as often as necessary. When setting the clock or alarm time, for accurate hour and minute adjustment always make sure you press the HR and MIN keys separately and not simultaneously. Select your waveband using the BAND switch. Press and hold down the HR or MIN key to set and adjust the hours and minutes respectively: · With your finger held down on HR, the hour increases as a digit from 0 to 23. Release the HR or MIN key when you have reached the correct time. If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you up!Before or during the set alarm time goes off, push the ALARM switch to OFF position. tM Alarm indicator disappears from display. SLEEP About Sleep The clock radio has a built-in timer called SLEEP, which enables the radio to be automatically switched off after 59 minutes. SLEEP allows you to lie back, listen and fall asleep. Set your sleep time by pressing once on the SLEEP key. The display shows the sleep period 0: 59. To cancel the sleep function before the sleep period ends, press SLEEP OFF /REPEAT ALARM. If you do not intend to use the clock radio for a long time, disconnect the set by withdrawing the plug from the wall socket. [. . . ] If you do not intend to use the clock radio for a long time, disconnect the set by withdrawing the plug from the wall socket. The battery should also be removed to prevent chemical leakage which will damage your set. To clean your set from fingerprints, dust and dirt, use a clean and soft damp cloth or chamois leather. Do not use cleaning products which contain, benzene, thinner, etc. [. . . ]