User manual PHILIPS AJ3925

[. . . ] If a plug without a fuse is used, the fuse at the distribution board should not be greater than 3 Amp. Note:The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · Connect the blue wire to the terminal marked N or coloured black. [. . . ] The current track number is displayed for several seconds (See 3), then it will switch back to clock display. 8 To interrupt, press );. To resume playback, press ); again. 10 To switch off CD playback and back to standby, press POWER. 1 2 3 4 5 Radio 1 2 Press POWER to switch on from standby. Select RADIO source by pushing CD·RADIO·BUZZER to RADIO (located on the side panel). Push BAND to FM or MW to select desired waveband. To view radio information, press DISPLAY. The current waveband and frequency will be displayed for several seconds (See 2), then it will switch back to clock display. To switch off radio and back to standby, press POWER. The display lights off. 3 4 5 6 7 CD Player · · Selecting a different track Press / § once or repeatedly until the desired track number appears on the display. In the stop position, press ); to start playback. Notes: ­ During playback, when shuffle mode is selected, shuffle play will begin only when playback of current track comes to an end. ­ Selection of shuffle mode is not available in the program mode. 2 2 3 1 2 3 4 Connecting an external device You can listen to the sound of the connected external device through your AJ3925's speakers. 1 2 Press POWER to switch on from standby. Use the supplied line-in cable to connect AJ3925's AUX jack to an AUDIO OUT or headphone jack on an external equipment (such as CD player, or VCR). AUX mode will auto switch on to play the sound, overriding the active CD or RADIO mode. 5 Alarm Using the alarm AJ3925 allows you to simultaneously set two different alarms (ALARM 1 and ALARM 2 ) which can go off in the CD, radio or buzzer mode. The clock time needs to be set correctly before using alarm. Setting alarm time Press and hold ALARM 1 or ALARM 2 until clock digit(s) for hour flashes. ALM1 or ALM2 is also displayed, flashing. It will exit the clock setting mode without setting if there is 5-second inactivity. Press repeatedly, or hold down / § to adjust the hours. Press corresponding ALARM 1 or ALARM 2 to confirm the hour setting. Press repeatedly, or hold down / § to adjust the minutes. [. . . ] The corresponding ALM1 or ALM2 is still displayed. Repeat alarm This will repeat your alarm call at 6-minute intervals. During the alarm call, press REPEAT ALARM as indicated by the arrow located at the top panel. The corresponding ALM1 or ALM2 is still displayed, yet flashing. [. . . ]