User manual PHILIPS AJ3977

[. . . ] 1 Connect the power plug to the wall outlet. 2 Insert 2 x AA batteries into the battery compartment. . · Replace the batteries once a year, or as often as necessary. Alarm Alarm General Two different alarm times ALARM1 and ALARM2 can be set in the radio, CD or buzzer mode. Switching off the alarm There are 3 ways of switching off the alarm. Unless you choose to cancel the alarm completely, the Daily Alarm Reset option will be automatically selected after 60 minutesfrom the time your alarm time first goes off. Setting the alarm time and mode 1 2 Check the set is switched off. [. . . ] Direct the aerial by turning the whole set. 1 Programming radio stations You can store up to a total of 20 radio stations in the memory (10 FM and 10 MW), manually or automatically (Autostore). Manual programming 1 Tune to your desired station (see Tuning to radio stations). 2 Press SET TIME/PROGRAM to activate programming. 3 Press 3, 4 once or more to allocate a number from 1 to 10. 5 Repeat steps 1-4 to store other stations. Helpful hints: - You can erase a preset station by storing another frequency in its place. Autostore Autostore automatically starts programming radio stations from preset 1. · In TUNER mode, press and hold SET TIME/PROGRAM until the frequency and PROG flash. Available stations are programmed (FM and MW). P and a preset number (1 10) appear when a station is stored. (See 6) After all stations are stored, the first autostore preset station automatically plays. To listen to a preset station Press the PRESET3, 4 buttons once or more until the desired preset station is displayed. W CLASS 1 LASER PRODUCT AJ 3977 Printed in China YM-527 CD player CD playback This set can play audio discs including CD-R and CD-RW. Do not try to play a CD-ROM, CDI, VCD, DVD or computer CD. · CDs encoded with copyright protection technologies by some record companies may be unplayable by this product. 2 Insert a CD with the printed side facing up, and close the CD door. 3 Press y to on, then press CD/ TUNER once or more to select CD. Display shows -- and later, the total number of tracks. 4 Press PLAY/PAUSE 2; to start playback. Display shows briefly current track number and returns to the clock display. · If necessary, press DISPLAY to toggle the clock and CD display. (See 7) Press 2; again to resume playback. [. . . ] To cancel sleep, press: · SLEEP once or more until 00 appears. Helpful hints: - The active alarm will be switched on when the SLEEP function is deactivated. · · Safety information (See @) Place the set on a hard and flat surface so that the system does not tilt. Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. [. . . ]