User manual PHILIPS AJL305

[. . . ] · Connect the brown wire to the terminal marked L or coloured red. · Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Recording and playback of material may require consent. [. . . ] Press HOUR+ or UP, DOWN repeatedly or hold them until the desired hour is displayed. 5 Press BACK to stop scanning. 7 Press MIN+, or UP, DOWN repeatedly or hold them until the desired minute is displayed. Press DOWN to highlight Wake to. . . . 8 9 10 Press SELECT. Tuner and Buzzer are displayed on the second display. 11 Press UP or DOWN repeatedly or hold them to select the desired alarm sound. 12 Press SELECT to save setting and exit. ­ Helpful hints: You can enter alarm setting quickly by pressing and holding ALARM on the set. Setup-Slideshow Setting Slideshow You can toggle slideshow on or off, and set the frequency of slideshow. 1 Press UP or DOWN repeatedly to highlight Slideshow. On, Off are displayed on the second display. Setup - Auto Brightness Setting Auto Brightness The set can automatically dim at the start time and light up at the end time. Press DOWN repeatedly to highlight Auto Brightness. Press SELECT. 5 6 Press SELECT. Press UP or DOWN repeatedly to switch Auto Brightness function on or off. 4 5 6 Press UP or DOWN repeatedly to switch slideshow on or off. Press DOWN to highlight Frequency. 7 8 Press BACK to return. Press DOWN repeatedly to highlight Timer Settings. 7 8 Press SELECT. Press UP or DOWN to switch between the following intervals: 5 sec->30 sec->1 min->10 min->30 min. 9 Press SELECT. 10 Press or hold HOUR+ below the second display or DOWN to select the desired start time. 9 Press BACK to exit setting. 11 Press or hold HOUR+ below the second display or DOWN to select the desired end time. ­ Helpful hints: You can set the timer to start at night and end in the morning so that AJL305 automatically dims at night and lights up in the morning. Setup-Clock Display/Memory Status Setup-Clock Display You can set whether to display clock or not in photo mode. Press UP or DOWN repeatedly to highlight Clock Display. 1 1 Clock/Alarm Displaying clock Press CLOCK. To activate or deactivate alarm Press ALARM repeatedly. Repeating alarm Viewing Memory Status You can check the occupied memory and how much capacity is left. Press DOWN repeatedly to highlight Memory Status. The memory occupation status of photo and voice memo is displayed respectively. ­ You can repeat the alarm call at 9-minute intervals. During the alarm call, press REPEAT ALARM / BRIGHTNESS CONTROL. Helpful hints: During alarm call, if no button is pressed, alarm call will last 30 minutes. Note: For instructions on setting the clock and alarm, please refer to chapter Setup - Clock and Setup - Alarm. ­ 4 5 Press UP to enter other settings. Press BACK to exit setting. ­ Helpful hints: During setting the set, if no button is pressed within 10 seconds, the set returns to SETUP mode automatically. Tuner Tuning to radio station 1 Press TUNER to switch on radio (FM only). [. . . ] Synchronization is interrupted and the set fails. ­ · The software of this set is corrupted. Connect the set to your PC and synchronize the set again by using AJL305 Photo Manager. Occasional crackling sound during FM broadcast. Extend the pigtail antenna fully. The screen brightness keeps turning dark. [. . . ]