User manual PHILIPS AQ4150-05S

[. . . ] Locking This control helps to prevent any of the other front panel controls from being accidentally pressed when you are listening to the radio or when you are not using the radio. Use at high volume can impair your hearing!Traffic Safety: Do not use headphones while driving or cycling as you may cause an accident!AQ4150-05S POWER SUPPLY Mains Adapter (not included) The voltage of the 3V adapter must match with the local voltage. [. . . ] Always disconnect the mains adapter if you are not using it. Remove the batteries from the set if they are exhausted or not to be used for a long time. ­ When the batteries are running low, flashes in the display. if the radio is on , it will automatically switch off. ­ It may be necessary to reprogramme your preset stations. sETTING THE CLOCK Clock display The time is displayed using the 24-hour clock system. The clock display is shown when the radio and cassette functions are switched off. ­ The clock digits flash for about 5 seconds when you press TIME SET. 2 To set the hour/minutes , press HOUR or MIN while the display is still flashing. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Press TUNING + or ­ briefly, once or more until the right frequency is found. In this way, the frequency can be changed step by step. The set yourself, as this will invalidate your guarantee. Hum when using mains adapter ­ Adapter used is unsuitable · Use a good quality regulated 3V DC adapter Poor sound/ no sound ­ Headphone plug not fully inserted · insert plug fully ­ Volume is turned down · Turn up volume ­ Tape head dirty · Clean tape head (see MAINTENANCE) Severe radio hum/distortion ­ FM aerial (headphone cord) not fully extended · Move set away from other electrical equipment ­ Batteries weak · Insert fresh batteries Front panel controls/ display does not function properly ­ Electrostatic discharge · Use the tip of the headphone plug/ball-point pen to press RESET and then reprogramme settings The model number is found at the back of the set and the production number in the battery compartment. This product complies with the radio interference requirements of the European Union. Automatic tuning 1 Press and hold down the TUNING + or ­ control until the display frequency starts to run. 2 When a station of sufficient strength has been found tuning stops, or you can stop automatic tuning by pressing either TUNING + or ­ control again. 3 Repeat steps 1 and 2 until you have found the desired station. [. . . ] 2 When a station of sufficient strength has been found tuning stops, or you can stop automatic tuning by pressing either TUNING + or ­ control again. 3 Repeat steps 1 and 2 until you have found the desired station. SELECTING & STORING FREQUENCIES: PRESETS You can store the frequencies of up to 10 radio stations in the memory, 5 on each wave band. A stored frequency is only erased from the memory by storing another frequency in its pIace. [. . . ]