User manual PHILIPS AQ4420-04M

[. . . ] Locking This button helps you to prevent any of the other front panel controls from being accidentally pressed when you are listening to the radio or when you are not using the radio. The seconds are synchronized with the flashing colon `:' second by second, and also by the 12-segment analogue clock display, where each segment represents 5 seconds. TM With your finger held down on HR , the hour will increase steadily as a number from 1-12 or 0-23. [. . . ] TM With your finger held down on MIN, the minutes will increase rapidly and continuously. Usually the frequency step has been preset in the factory for your area. The tuning step on this set is also combined with the hour clock display where: 10 KHz uses the 12-hr clock 9 KHz uses the 24-hr clock All preset stations will be lost and need to be programmed again when you change the tuning step. Press RADIO ON-OFF twice to select FM TM STEREO appears on the display when you are receiving a FM stereo transmission. 3 Select your station by one of the following: TM by using the ­ TUNING + control (down or up); TM pressing one of the Preset memory buttons 0-9 for a preset station; TM Direct Access Tuning, by entering the known band frequency. 4 Adjust the sound with VOLUME and DBB (Dynamic Bass Boost) controls. 5 To turn off the radio, press RADIO ON-OFF once or until the display shows OFF and reverts to the clock mode. TUNING + (up) 5 seconds or more to select a tuning step of 10 KHz and the 12-hr clock. TUNING ­ (down) 5 seconds or more to select a tuning step of 9 KHz and the 24-hr clock. Finding your Preset station 1 Preset RADIO ON-OFF once or more to select the desired waveband. 2 Press the preset number of your desired station. All settings must now be reprogrammed into the memory. 4 To start playback, press 1 2 TM The display shows tAPE and the analog clock segments throughout the tape mode 5 Adjust the sound with the VOLUME and DBB controls. TM The display shows OFF before reverting to the clock mode. aUTO REVERSE The tape direction will be automatically reversed each time the tape reaches the end. Cassette playback continues in this way unless you press 9 or until batteries are exhausted. Use at high volume can impair your hearing!Traffic Safety: Do not use headphones while driving or cycling as you may cause a traffic accident! [. . . ] mAINTENANCE · For quality playback, clean the magnetic head after every 50 hours of operation or, on average once a month by playing through a cleaning tape. Do not expose the set and cassettes to rain, moisture, sand, or to excessive heat e. ENVIRONMENTAL NOTE 1 The packaging has been minimized so that it is easy to separate into two mono-materials: cardboard, and polyethylene. [. . . ]