User manual PHILIPS AQ5120

[. . . ] The type plate is located on the bottom of the set. General Operation/ Radio General operation Switching on and off and selecting functions 1 2 To switch on, push the Source selector slider to TAPE or RADIO as desired. To switch off, push the Source selector to TAPE/OFF and check the cassette keys are released. AQ5120 Top and front panels (See 1) 5 6 7 8 1 FM STEREO indicator ­ lights up for stereo FM reception. 2 Cassette recorder keys: PAUSE ; ­ pauses playback or recording STOP·EJECT 9/ ­ stops playback or recording. [. . . ] By pressing F. FWD/REWIND 5 or 6, fast forwading/ rewinding of the tape is possible in both directions. During playback, the keys are automatically released at the end of a tape and the set is switched off (unless PAUSE ; mode has been activated. ) During fast forwarding/rewinding, the keys will not be released at the end of a tape. To switch off the set, make sure the cassette keys are also released. · · General information on recording Recording is permissible insofar as copyright or. other rights of third parties are not infringed. For recording, use only NORMAL type cassettes (IEC type I) on which the tabs have not yet been broken. This deck is not suited for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. The best recording level is set automatically. Altering the VOLUME will not affect the recording. To protect a tape from accidental erasure, break out the tabs. If you wish to record again, cover the tabs with a piece of adhesive tape. Recording from the Radio 1 2 3 4 5 6 Select RADIO source. Tune to the desired radio station (see Radio reception). Making your recording 1 2 3 4 Select TAPE source. Follows steps 3-4 under Recording from the Radio. [. . . ] If you are unable to remedy a problem by following these hints, consult your dealer or service centre. http://www. philips. com WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. · 3 4 5 · · Problem ­ Possible cause · Remedy No sound /power ­ Volume not adjusted · Adjust the VOLUME ­ Power cord not securely connected · Connect the AC power cord properly ­ Batteries dead/ incorrectly inserted · Insert (fresh) batteries correctly ­ Headphones connected to the set · Disconnect headphones. Display does not function properly/ No reaction to operation of any of the controls ­ Electrostatic discharge · Switch off and unplug the set. [. . . ]