User manual PHILIPS AQ5150-05S

[. . . ] If it does not, consult your dealer or service center. If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains. Connect the power cord to the AC INPUT inlet and the wall socket. The power cord is now connected and ready for use. To switch the set off completely, withdraw the power cord from the wall socket. [. . . ] To switch off, push the Source selector to TAPE and check the cassette keys are released. 2 3 4 · Helpful hints: ­ To change from TAPE to RADIO , or when you are switching off the set: first, make sure you press the STOP·EJECT 9/ key to end playback and all the cassette keys are released. Adjusting volume Adjust the volume with the VOLUME control. · Radio reception Adjust the source selector to RADIO. Adjust the band selector to select your desired waveband, MW or FM. - FM STEREO lights up for stereo FM reception. To switch off the radio, adjust the source selector to TAPE position. 4 To improve radio reception: CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. · For FM, extend and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. · Cassette Recorder Cassette playback 1 2 Push the Source selector to TAPE Press STOP·EJECT 9/ to open the cassette holder and insert a cassette and close the deck. By pressing F. FWD/REWIND 5 or 6, fast forwading/ rewinding of the tape is possible in both directions. During playback, the keys are automatically released at the end of a tape and the set is switched off (unless PAUSE ; mode has been activated. ) During fast forwarding/rewinding, the keys will not be released at the end of a tape. To switch off the set, make sure the cassette keys are also released. To guard against this, set your volume to a safe level before your hearing adapts and leave it there. To establish a safe volume level: Set your volume control at a low setting. Slowly increase the sound until you can hear it comfortably and clearly, without distortion. Listen for reasonable periods of time: Prolonged exposure to sound, even at normally "safe" levels, can also cause hearing loss. Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for reasonable periods of time. Be careful not to adjust the volume as your hearing adapts. Do not turn up the volume so high that you can't hear what's around you. You should use caution or temporarily discontinue use in potentially hazardous situations. Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc. ; it may create a traffic hazard and is illegal in many areas. 1 2 3 4 · · · · · · · · · · · Safety information Place the set on a flat, hard and stable surface so that the system does not tilt. [. . . ] Do not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. [. . . ]