User manual PHILIPS AQ5190

[. . . ] Connect the power cord to the AC INPUT inlet and the wall socket. The power cord is now connected and ready for use. To switch the set off completely, withdraw the power cord from the wall socket. Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. Helpful hints : To avoid unnecessary energy consumption, always adjust the Source selector to TAPE(OFF) after using the set. [. . . ] Helpful hints : To avoid unnecessary energy consumption, always adjust the Source selector to TAPE(OFF) after using the set. Also check that the tape deck keys are released. . General Operation / Radio General operation Switching on and off and selecting functions 1 2 To switch on, push the Source selector slider to TAPE or RADIO as desired. To switch off, push the Source selector to TAPE/OFF and check the cassette keys are released. Helpful hints: To change from TAPE to RADIO , or when you are switching off the set: first, make sure you press the STOP·EJECT 9/ key to end playback and all the cassette keys are released. 2 3 4 · Adjusting volume · Adjust the volume with the VOLUME control. Radio reception 1 Adjust the source selector to RADIO. Adjust the band selector to select your desired waveband, MW or FM. - FM STEREO lights up for stereo FM reception. To switch off the radio, adjust the source selector to TAPE (OFF) position. 2 3 The type plate is located on the bottom of the set. 4 To improve radio reception: · For FM, extend and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. For MW, the set uses a built-in antenna. Press ; and clean the heads A, and the capstan B. Cleaning of the heads can also be done by playing a cleaning cassette through once. · · Safety information Place the set on a flat, hard and stable surface so that the system does not tilt. Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. The apparatus shall not be exposed to dripping or splashing. Adequate ventilation with a minimum gap of 15cm (6 inches) between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. Do not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. [. . . ] No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. · · · · · C B A A · · 7 Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. [. . . ]