User manual PHILIPS AQ5191

[. . . ] 5 MIC (built-in microphone) ­ for voice recording 6 Band selector: MW, FM ­ selects wavebands, MW or FM 7 Source selector : TAPE (OFF), RADIO ­ selects tape or radio source of sound ­ switches off the set 8 TUNING rotary ­ tunes to radio stations 2 3 4 Power supply Whenever convenient, use the power cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. Batteries (not included) Insert 6 batteries, type R20 or D-cells (preferably alkaline) with the correct polarity. (See 1) Batteries contain chemical substances, so they should be disposed of properly. [. . . ] (See 1) Batteries contain chemical substances, so they should be disposed of properly. · Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst: Do not mix battery types: e. g. Only use batteries of the same type for the set. When inserting new batteries, do not try to mix old batteries with the new ones. Remove the batteries if the set is not to be used for a long time. Helpful hints: ­ To change from TAPE to RADIO , or when you are switching off the set: first, make sure you press the STOP·EJECT 9/ key to end playback and all the cassette keys are released. Adjusting volume Adjust the volume with the VOLUME control. · · Radio reception 1 2 3 Adjust the source selector to RADIO. Adjust the band selector to select your desired waveband, MW or FM. - FM STEREO lights up for stereo FM reception. To switch off the radio, adjust the source selector to TAPE (OFF) position. · 9 @ 0 ! 4 · To improve radio reception: · For FM, extend and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. 1 2 3 4 Open the cassette holder by pressing 9/. Press ; and clean the heads A, and the capstan B. Cleaning of the heads can also be done by playing a cleaning cassette through once. · Safety information · · Place the set on a flat, hard and stable surface so that the system does not tilt. Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. The apparatus shall not be exposed to dripping or splashing. Adequate ventilation with a minimum gap of 15cm (6 inches) between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. Do not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] Do not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. [. . . ]