User manual PHILIPS AQ6601

[. . . ] Memory protection The memory protection acts as a backup should there be a power failure or interruption. When changing batteries or power supply, the time setting, presets and the last station listened to are retained for about 30 minutes. [. . . ] Release HOUR when you reach the correct hour setting. ­ With your finger held down on MIN, the minutes increase rapidly and continuously. Usually the frequency step has been preset in the factory for your area. The tuning step on this set is also combined with the hour clock display where: 10 KHz uses the 12-hr clock 9 KHz uses the 24-hr clock All preset stations will be lost and need to be programmed again when you change the tuning step. TUNING + (up) 5 seconds or more to select a tuning step of 10 KHz and the 12-hr clock. TUNING ­ (down) 5 seconds or more to select a tuning step of 9 KHz and the 24-hr clock. 4 Select your station by pressing one of the preset numbers (1-5), or by using the TUNING controls + or ­. BAND once or more until OFF appears briefly. Clean the tape heads every month with a cotton bud dipped in alcohol, or by playing through a cleaning tape. ⷠUse a soft damp cloth to wipe off dust and dirt. Don't use benzene or corrosives to clean the set. ⷠDon't expose the set or cassettes to rain, moisture, sand or to excessive heat e. The packaging has been minimized so that it is easy to separate into two materials: cardboard and plastic. Please inquire about local regulations on how to hand in your old set for recycling. [. . . ] ⭠PRESET appears in the display. 3 To listen to a preset station, select your wave band and then press the preset number of your desired station. [. . . ]