User manual PHILIPS AT754

[. . . ] Register your product and get support at Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. 1) 1 2 3 4 Protection cap Shaving unit Shaving unit release button Shaver on/off button (AT893/AT891/AT890/AT754/AT753/AT752/ AT751/AT750 only) 5 Charging light (AT893/AT891/AT891/AT754/AT753/AT752/AT751/ AT750 only) 6 Charging stand (AT940 only) 7 Adapter 8 Cleaning brush 9 Battery symbol and plug symbol (AT940 only) 10 Shaver on/off button (AT940 only) 11 Trimmer release slide (AT940/AT893/AT891/AT890 only) 12 Trimmer (AT940/AT893/AT891/AT890 only) Not shown: Storage pouch (AT940/AT893/AT891/AT890 only) Note:You can find the type number on the back of the shaver. [. . . ] - For optimal shaving results, make circular movements during use. - The shaver is waterproof and can be used in the bath or shower. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Wet shaving 1 Apply some water to your skin. 3 Rinse the shaving unit under the tap to ensure that the shaving unit glides smoothly over your skin. 4 Press the on/off button once to switch on the shaver. 5 Move the shaving heads in circular movements over your skin. Note: Rinse the shaver under the tap regularly to ensure that it continues to glide smoothly over your skin. 6 After shaving, press the on/off button once to switch off the shaver and dry your face. 7 Clean the shaver (see chapter `Cleaning and maintenance'). Note: Make sure you rinse all foam or shaving gel off the shaver. Dry shaving 1 Press the on/off button once to switch on the shaver. 2 Move the shaving heads in circular movements over your skin. 3 After shaving, press the on/off button once to switch off the shaver. Trimming (AT940/AT893/AT891/AT890 only) You can use the trimmer to groom your sideburns and moustache. 3 After trimming, press the on/off button once to switch off the shaver. Cleaning and maintenance Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the charging stand (AT940 only). Always unplug the shaver before you clean it under the tap. - For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110). Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the shaver when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. [. . . ] Shaving heads - We advise you to replace your shaving heads every two years. Always replace with HQ9 Philips Shaving Heads (for AT940) or HQ8 Philips Shaving Heads (for AT893/AT891/AT890/AT754/AT753/AT752/AT751/ AT750). Cleaning Use Cleaning spray (HQ110) to clean the shaving heads thoroughly. Environment Do not throw away the appliance with the normal household waste at the end of their life, but hand them in at an official collection point for recycling. [. . . ]