User manual PHILIPS AT9240

[. . . ] Switches the player on, starts or pauses CD play 3 9 . Stops CD play, clears a CD program or switches the player off 4 §. 5 mm headphone socket, socket to connect the player to another analogue audio input of an additional appliance, remote control socket $ VOL E. With this player you can use either: · Notes: ­ Old and new or different types of batteries should not be used in combination. [. . . ] ­ During SHUFFLE, SHUFFLE REPEAT ALL, REPEAT or while playing a program, searching is only possible within the particular track. You can select up to 99 tracks and store them in memory in a desired sequence. 1 While playback is stopped, select a track with or §. Y PROGRAM lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROGRAM for more than 2 seconds. Notes: ­ If you press PROGRAM and there is no track selected, SELECt is displayed. ­ If you try to store more than 99 tracks, FULL is displayed. Y CLEAr is displayed once, PROGRAM goes off and the program is cleared. Notes: The program will also be cleared if you ­ interrupt the power supply or ­ open the CD lid. When restarting, playback continues from where you have stopped. Y RESUME is shown and playback continues from where you have stopped. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. When a key is pressed, no action will be executed then. Note: When you deactivate HOLD by switching the slider to RESUME and restart, playback continues from where you have stopped. With a conventional portable CD player you might have experienced that the music stopped e. The ELECTRONIC SKIP PROTECTION prevents loss of sound caused by light vibrations and shocks. However, ESP does not prevent playback interruptions during serious running. It also does not protect the set against any damage caused by dropping!It is possible to play tracks in random order, to repeat a track or the CD and to play the first few seconds of each track. 1 Press · MODE during playback as often as necessary until the display shows either: y SHUFFLE: All tracks of the CD are played in random order until all of them have been played once. y SHUFFLE REPEAT ALL: All tracks of the CD are played repeatedly in random order. Y REPEAT: The current track is played repeatedly. [. . . ] 6 Make sure the cord does not hinder your driving. 7 Start the CD player, set VOL E to position 8 and adjust the sound with the car radio controls. ⷠAlways remove the voltage converter from the cigarette lighter socket when the CD player is not in use. Notes: ­ Avoid excessive heat from the car heating or from direct sunlight (e. [. . . ]