User manual PHILIPS AUDIO CD RECORDER CDR760BK99

[. . . ] Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. Follow Instructions - All operating and use instructions should be followed. Water and Moisture - The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like. [. . . ] Lights up during finalizing and flashes in finalize standby 9 ERASE . Lights up during erase recording and flashes in erase standby 0 COPY PROHIBIT . Lights when trying to record digital protected audio !Player is reading disc information OPC . Laser power calibration performed 96 times, finalize disc COAXIAL . Flashes during unfinalize disc standby, lights during unfinalize disc INPUT . The CD recorder has the following recording inputs: - Digital optical input - Digital coaxial input - Analogue input The CD recorder has the following playback outputs: - Digital coaxial output - Analogue output The connections to be made depend upon the possibilities your audio equipment offers. If your equipment does not offer digital connections, the high quality Analogue-Digital-Converter of your CD recorder will ensure high audio performance when recordings are made from the analogue input. playback via the digital coaxial output of the CD recorder gives the best audio performance. If your equipment does not offer digital connections the high quality Digital-AnalogueConverter of the CD recorder ensures a high sound quality via the analogue output. We recommend that both digital and analogue connections be made, so that analogue recordings can be made when digital recording is not possible. The most common ways of connecting the CD recorder are explained below. If you still have difficulties with the connections, feel free to contact the Philips Consumer Service desk in your country. Recording will not start or will stop after 4 seconds. â· The Serial Copy Management System (SCMS) only allows digital recording under specific conditions: - It is not possible to make a digital copy from a digital copy. - Analogue recording is always possible!- The number of recordings from the original is unlimited. Digital recordings can be made from CDs (or other sources with an output Sample Frequency of 44. 1 kHz +/- 100 ppm) via the digital input. Important: If you want to play the recorded CD-R disc on a regular CD player, it must be finalized first. Preparing for digital recording 1 Make sure the disc is absolutely free of scratches and dust particles. 3 Press AUTO/MANUAL to switch between auto and manual track numbering. [. . . ] - To add more tracks to the program, repeat steps 1 through 4. - If you try to store more than 30 tracks, FULL appears on the display 5 Press PLAY to start programmed play. clearing a program 1 Press STOP if necessary to stop programmed play. 2 Press STOP again to clear the program. [. . . ]