User manual PHILIPS AW7150-05P

[. . . ] Then press PAUSE ; and clean the capstan C, and recording/playback head A and B. After cleaning, press STOP / Cleaning of the heads A and B can also be done by playing a cleaning cassette through once. See page 7 This unit complies with the radio interference requirements as laid down in EC (European Commity) regulations) The type plate is located on the rear of the set. Remarks Fingerprints, dust and dirt on the set can be removed by using a soft, clean and slightly damp leather cloth. [. . . ] Remarks Fingerprints, dust and dirt on the set can be removed by using a soft, clean and slightly damp leather cloth. Do not use any cleaning agents, since they may damage the cabinet. Do not expose the set, batteries and cassettes to rain, moisture, sand, or to excessive heat e. From heating equipment or in motor cars parked in the sun. You may connect stereo headphones with 3. Reduce its length if the FM signal is too strong (usually occurs when very close to a transmitter). ­ For MW/AM or LW, the set is provided with a built-in aerial, so there is no need to use the telescopic aerial. The aerial can be directed by turning the whole set. When ST 6 0 lights up, you are receiving a FM-stereo transmitter. Any disturbing noise, due to a weak FM-stereo signal can be suppressed by setting the MONO/STEREO switch $ to MONO. These controls do not affect the recording. Press STOP / if you want to stop the recording before the end of he tape. The set is switched off if the MODE selector is in position TAPE and no buttons are pressed. DUBBING ­ Copying from deck A to B When dubbing, it is recommended to use fresh batteries or to connect the set to the mains supply. ­ NOR - for normal speed copying; Do not switch this switch during dubbing. Press both EJ / buttons and insert a recorded cassette into deck A and a cassette which is suited for recording into deck B (fig. Notes: During recording, buttons in deck A should not be pressed (except for PLAY 1 during dubbing). If during the recording of a MW/AM or LW station, a whistling sound is heard, this sound can be suppressed by setting the BEAT CUT switch $ to another position. Set the VOLUME control 3 to the minimum volume level (during microphone recordings, monitoring is not possible) If a problem occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. [. . . ] Set the VOLUME control 3 to the minimum volume level (during microphone recordings, monitoring is not possible) If a problem occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. Warning: Under no circumstances should you try to repair the set yourself, as this would void the warranty. Fix new fuse which should be a BS1362 5 Amp, A. [. . . ]