User manual PHILIPS AW7502

[. . . ] i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories k Use only with the cart, stand, tripod, bracket, the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tipover. l Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] Access and exit a menu. 3 Get started Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. r iPod/iPhone Select iPod/iPhone source. s DAB/TUNER Select DAB/tuner source. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the rear of the apparatus. ___________________________ Placement mount the unit on a wall. Mount on a wall To wall mount the unit, see the included separate sheet of wall mounting instructions. Prepare the remote control Caution Risk of explosion!Keep batteries away from To insert the remote control battery: 1 2 3 Open the battery compartment. Insert 2 AAA batteries (not supplied) with correct polarity (+/-) as indicated. Close the battery compartment. 10 EN 1 2 Auto install radio stations When you connect power and no radio stations are stored, the unit automatically begins to store radio stations. Note If you are not going to use the remote control for a long time, remove the batteries. Do not use old and new or different types of batteries in combination. Batteries contain chemical substances, so they should be disposed of properly. 1 Connect the unit to the power supply. » [AUTO INSTALL PRESS - PLAY KEY](auto install press - play key) is displayed. / to switch between [Y] and Manual tune channel/frequency manually. In addition to antenna orientation for better radio reception, the optimal reception can also be obtained with this feature. 1 2 3 4 In the DAB mode, press MENU to display the "Manual tune" option. Press ENTER » The display shows a channel and its frequency. Press / repeatedly until the desired channel/frequency appears. Press ENTER Tip You may press DISPLAY to change the service information on the display. You may adjust the position of the antenna to obtain the optimal signal strength. 5 Press ENTER System With this feature, you can: know the software version of the unit 1 2 3 4 In the DAB mode, press MENU to enter the menu options. repeatedly until [System] is Press ENTER » [SW version] is displayed. » The software version of the main unit is displayed. reset DAB/FM stations In the DAB mode, press MENU to enter the menu options. repeatedly until [System] is 1 2 3 4 Press MENU to exit manual tune function. Press ENTER » [SW version] is displayed. Press / to switch to [Tuner Reset]. EN 15 English 5 6 Press ENTER Press / to switch between [Y] and [N]. [. . . ] Connect the supplied MP3 link cable to: the MP3 LINK jack (3. 5mm) on the unit. the headphone jack on an external device. Start to play the device (see the device user manual). 3 Total output power Frequency response Signal to noise ratio MP3 link input 2 x 10 W RMS 80 Hz - 16 kHz, ± 3 dB > 60 dB 0. 5 V RMS 20 k Listen through headphone 1 Plug a headphone into the the unit. socket on Disc Laser type Disc diameter Support disc Semiconductor 12 cm /8 cm CD-DA, CD-R, CD-RW, MP3-CD, WMA-CD 24 Bits / 44. 1 kHz Audio DAC Total harmonic distortion < 1. 5% Frequency response 60 Hz -16 kHz (44. 1 kHz) Signal to noise ratio > 55 dBA EN 19 English 1 Press SLEEP/TIMER repeatedly until [OFF] (off) is displayed. [. . . ]