User manual PHILIPS AW7593

[. . . ] (and Model / Serial number) 1-800-661-6162 (Francophone) 1-888-PHILIPS (744-5477) (English speaking) Veillez à avoir votre produit à portée de main. (et model / serial nombre) 1-888-PHILIPS (744-5477) y tenga a mano el producto. (y número de model / serial) 2 1 2 34 5 6 7 8 5 9 0 ! *& ^ % $ # @ ( ) ¡ POWER MUTE TM CD RADIO £ VOL PRESET § 3 IMPORTANT SAFETY INSTRUCTIONS 1. Do not use this apparatus near water. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. [. . . ] 17 6 General Information The set complies with the FCC-Rules, Part 15 and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. Cleaning the disc lens After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good playback quality, clean the disc lens with any commercially available cleaner. Follow the instructions supplied with cleaner. Safety information Place the system on a flat, hard and stable surface. Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight. Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers table-cloths, curtains, etc. The apparatus shall not be exposed to dripping or splashing. Batteries contain chemical substances, so they should be disposed of properly AC power Connect the AC power cord to the wall socket. This switches on the power supply The type plate is located on the bottom panel. IMPORTANT!­ Never plug in the AC power cord to the power outlet before installation is completed. ­ Install your set near the AC outlet and where the AC power plug can be reached easily ­ Do not use a converter or extension cord. - Install the set as far as possible from sources of interference, such as a refrigerator, microwave oven, fluorescent lamp, etc. ­ There should be at least 2. 5" distance between the unit and the wall. 8 Installation Using the remote control IMPORTANT!­ Remove the protective plastic tab before using the remote control. ­ Always point the remote control directly towards IR area . To replace the battery Setting the clock The time is displayed using the 12-hour clock. 1 On the set, press and hold CLOCK 2 3 4 5 The hour digits start flashing (AM 12: 00 by default) Hold down or press or § repeatedly to set the hour Press CLOCK to confirm the setting The minute digits start flashing Repeat step 3 to set the minute Press CLOCK to confirm the setting The clock shows the set time 1 2 3 4 Press and hold 1 as indicated Simultaneously, pull the battery tray at 4 Remove the old batter y and put a new CR2025 battery in place Put back the battery tray 1 2 3 CR 20 25 TH IUM M To turn on the Daylight Saving Time (DST) mode 1 CAUTION!­ Remove the battery if it is exhausted or will not be used for a long time. ­ Batteries contain chemical substances, so they should be disposed of properly. 2 In the standby mode, press and hold DISP on the set Current time setting moves ahead by 1 hour. [. . . ] 4 signal-to-noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60dB Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 125Hz~16kHz Disc player Programmable tracks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80Hz~125kHz signal-to-noise . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50dB Audio distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]