User manual PHILIPS AX2011

[. . . ] Average playing time of batteries under normal conditions Battery type ESP on Normal 7 hours Alkaline 22 hours Rechargeable ECO-PLUS NiMH battery 10 hours ESP off 6 hours 19 hours 9 hours Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3362. 5V DC socket of the player and then to the wall socket. Recharging stops after a maximum of 7 hours, or when you start playback. Notes: ­ It is normal for the batteries to become warm during recharging. [. . . ] While the CD is read, 1 -:- flashes in the display. Bass adjustment You can choose between the bass enhancement levels dbb1 and dbb2. 1 Press BASS once for dbb1 and twice for dbb2. y dbb1 or dbb2 is displayed and is shown. 2 To switch dbb1 or dbb2 off, press BASS twice or once, respectively. Briefly press or § once or several times to skip to the current, previous or next track. Y Playback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. Y Searching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. Y Playback continues from this position. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. ­ In SHUFFLE, SHUFFLE REPEAT ALL or REPEAT mode (see MODE chapter), or while playing a program, searching is only possible within the particular track. You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 While playback is stopped, select a track with or §. Y PROGRAM lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROGRAM for more than 2 seconds. Notes: ­ If you press PROGRAM and there is no track selected, SELECt is displayed. ­ If you try to store more than 30 tracks, FULL is displayed. clearing the program · While playback is stopped, press 9 to clear program. [. . . ] Use FINALIZE on the CD recorder to complete the recording. Electrostatic discharge Disconnect the set from power supply or take out the batteries for a few seconds. If you are unable to solve a problem by following these hints, consult your dealer or service centre. Keep the player away from active mobile phones. [. . . ]