User manual PHILIPS AX2201

[. . . ] CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure. This product complies with the radio interference requirements of the European Union. Batteries (supplied or optionally available) You can use the following batteries with this CD-player: · Notes:­ Old and new or different types of batteries should not be combined. ­ Remove batteries if they are empty or if the player is not going to be used for a long time. [. . . ] Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4. Playing a CD This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. Selecting a track and searching Selecting a track during playback · Briefly press or § once or several times to skip to the current, previous or next track. YPlayback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. YSearching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. YThe current track number and elapsed playing time are displayed. YThe time at which playback was paused starts flashing. YThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. ⷠTo remove the CD, hold it by its edge and press the hub gently while lifting the CD. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. ­ In shuffle, shuffle repeat all or repeat mode (see MODE chapter), or while playing a program, searching is only possible within the particular track. Note: If there is no activity, the set will automatically switch off after a while to save energy. Programming track numbers You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 While playback is stopped, select a track with or §. YPROG lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROG for more than 2 seconds. [. . . ] If your lens has steamed up, wait a few minutes for this to clear. Disconnect power or remove batteries for a few seconds. Also keep away from active mobile phones. ⷠFor in-car use, check that the cassette adapter is inserted correctly, that the car cassette player's playback direction is correct (press autoreverse to change), and that the cigarette lighter jack is clean. [. . . ]