User manual PHILIPS AX2301-00C

[. . . ] · Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment. CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure. Batteries (supplied or optionally available) You can use the following batteries with this CD-player: · normal batteries type LR6, UM3 or AA (preferably Philips), or · alkaline batteries type LR6, UM3 or AA (preferably Philips). Notes:­ Old and new or different types of batteries should not be combined. [. . . ] Carefully insert the cassette adapter into the car radio's cassette compartment. Make sure the cord does not hinder your driving. Decease the volume on the set, if necessary. Start playback on the set and adjust the sound with the car radio controls. · Always remove the voltage converter from the cigarette lighter socket when the set is not in use. Note: If your car radio has a LINE IN socket , it is better to use it for the car radio connection instead of the cassette adapter. Connect the signal lead to this LINE IN socket and to LINE OUT/p on the set. Playing a CD This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. 1 Push the OPEN 2 slider to open the player. 2 Insert an audio CD, printed side up, by pressing the CD onto the hub. 3 Close the player by pressing the lid down. 4 9 4 3 LINE OUT / OP VOL EN Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. yPlayback starts with the selected track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. ySearching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. yPlayback continues from this position. 4 9 4 4 Press 2; to switch the player on and start playback. yThe current track number and elapsed playing time are displayed. · You can pause playback by pressing 2;. yThe time at which playback was paused starts flashing. · You can continue playback by pressing 2; again. yThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. · To remove the CD, hold it by its edge and press the hub gently while lifting the CD. [. . . ] 1 Press MODE during playback as often as required in order to activate one of the following `modes'. The active mode is shown in the display. · For in-car use, check that the cassette adapter is inserted correctly, that the car cassette player's playback direction is correct (press autoreverse to change), and that the cigarette lighter jack is clean. Allow time for temperature change. ESP With a conventional portable CD-player you might have experienced that the music stopped e. g. [. . . ]