User manual PHILIPS AX3224

[. . . ] Portable CD Player AX3211, AX3212, AX3213, AX3214, AX3215 AX3216, AX3217, AX3218, AX3219, AX3220 AX3221, AX3222, AX3223, AX3224, AX3225 Audio IM Read this manual first! If you have any problems, do not attempt to return this product to the store. RTAN PO For fast help, call us first!1-800-531-0039 Return your Warranty Registration Card within 10 days EE T! WH Y INS ID PHILIPS CONSUMER ELECTRONICS NORTH AMERICA Knoxville, Tennessee 37914-1810, U. S. A. E S 6 7 8 9 0 !@ # 5 4 3 2 1 $ % 1 QUICK START MISE EN SERVICE RAPIDE ENCENDIDO RAPIDO 1 OPEN 2 2. 2. AA LR6 UM3 1. 1. 3 CD 4 5 HOLDOFF O FF · RE SU M E ·H OL D LIN E OU T/ VOL. 0 6 PLAY 7 VOLUME !!! 2 IMPORTANT SAFETY INSTRUCTIONS 1. Do not block any of the ventilation openings. [. . . ] Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you. GENERAL INFORMATION / CD PLAY In-car use (connections supplied or optionally available) Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltage converter (4. 5 V DC, positive pole to the center pin) and the AY 3501 cassette car adapter. 1 Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. Plug the voltage converter into the cigarette lighter jack (only for 12 V car battery, negative grounding), then connect the wired end with 4. 5V DC input jack on the set. 12 V DC CD PLAY / FEATURES Playback information · If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded properly, nF dISC is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. · When playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. · Playback will stop if you open the CD lid. 4, 5 V DC Y A p 1 2 2 · While the CD is read, 1 -:- flashes in the display. Volume and bass Volume adjustment · Adjust the volume by using VOL E. 3 3 4 5 6 7 If necessary, clean the cigarette lighter jack to obtain a good electrical contact. Turn down the volume and connect the cassette adapter plug to LINE OUT/p on the set. Carefully insert the cassette adapter into the car radio's cassette compartment. Make sure the cord does not hinder your driving. Decrease the volume on the set if necessary. Start playback on the set and adjust the sound with the car radio controls. CD RE W RIT AB LE CO MP AT IB LE 4 Bass adjustment · Press DBB to switch the bass enhancement on or off y is shown if the bass enhancement is activated. · N · Always remove the voltage converter from the cigarette lighter jackwhen the set is not in use. Note: If your car radio has a LINE IN jack, it is better to use it for the car radio connection instead of the cassette. adapter. Connect the signal lead to this LINE IN jack and to LINE OUT/p on the set. Remote control (supplied or optionally available) Use the AY 3768 cord remote control. The buttons on the remote control have the same functions as the corresponding buttons on the set. 2 Firmly connect the remote control to LINE OUT/p on the set. 3 Adjust the volume VOL E on the CD player and remote control. C · N Playing a CD This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. 1 Push the OPEN 2 slider to open the player. 2 Insert an audio CD, printed side up, by pressing the CD onto the hub. 3 Close the player by pressing the lid down. 4 Press 2; to switch the player on and start playback. [. . . ] It also does not protect the unit against any damage caused by dropping!It is possible to set ESP off and enter the Power Save mode. The Power Save mode helps to extend battery lifetime for longer playback. · Press MODE for more than 2 seconds. [. . . ]