User manual PHILIPS AX5002

[. . . ] Switches the player on, starts or pauses CD play 3 9 . Stops CD play, clears a program or switches the player off 4 §. This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds 0 . 5 mm headphone socket, socket to connect the player to another audio input of an additional appliance, remote control socket (not on all versions) # VOL E. [. . . ] 2 To switch dbb1 or dbb2 off, press BASS twice or once, respectively. Briefly press or § once or several times to skip to the current, previous or next track. Y Playback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. Y Searching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. Y Playback continues from this position. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. ­ In SHUFFLE, SHUFFLE REPEAT ALL or REPEAT mode (see MODE chapter), or while playing a program, searching is only possible within the particular track. You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 While playback is stopped, select a track with or §. Y PROGRAM lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROGRAM for more than 2 seconds. Notes: ­ If you press PROGRAM and there is no track selected, SELECt is displayed. ­ If you try to store more than 30 tracks, FULL is displayed. clearing the program · While playback is stopped, press 9 to clear . Program y CLEAr is displayed once, PROGRAM goes off, and the program is cleared. Note: The program will also be cleared if the power supply is interrupted, or if the CD-player lid is opened, or if the set switches off automatically. It is possible to play tracks in random order, to repeat a single track or the entire CD, and to play the first few seconds of each track. 1 Press MODE during playback as often as required in order to activate one of the following `modes'. [. . . ] ­ If your car radio has a LINE IN socket, it is better to use this instead of the cassette adapter. Simply connect a signal lead from the LINE OUT/p socket of the CD-player to this LINE IN socket. Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. No power, playback does not start Mains adapter Loose connection In-car use Cigarette lighter is not powered when ignition is off. [. . . ]