User manual PHILIPS AX5006

[. . . ] ⭠If the batteries become too warm , recharging will be interrupted for approximately 30 minutes and Hot is displayed. ­ To ensure proper recharging on board, take care that contacts are clean. Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it. [. . . ] This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. Y The current track number and elapsed playing time are displayed. Y The time at which playback was paused starts flashing. Y The total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. ⷠTo remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: If there is no activity, the set will automatically switch off after a while to save energy. If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded properly, nF dISC is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. ⷠWhen playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. Y CLEAr is displayed once, PROGRAM goes off, and the program is cleared. Note: The program will also be cleared if the power supply is interrupted, or if the CD-player lid is opened, or if the set switches off automatically. It is possible to play tracks in random order, to repeat a single track or the entire CD, and to play the first few seconds of each track. 1 Press MODE during playback as often as required in order to activate one of the following `modes'. the active mode is shown in the display. Y SHUFFLE: All tracks of the CD are played in random order until all of them have been played once. y SHUFFLE REPEAT ALL: All tracks of the CD are played repeatedly in random order. Y REPEAT: The current track is played repeatedly. Y REPEAT ALL: The entire CD is played repeatedly. Y SCAN: The first 10 seconds of each of the remaining tracks are played in sequence. 2 Playback starts in the chosen mode after 2 seconds. [. . . ] ­ If your car radio has a LINE IN socket, it is better to use this instead of the cassette adapter. Simply connect a signal lead from the LINE OUT/p socket of the CD-player to this LINE IN socket. Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. No power, playback does not start Mains adapter Loose connection In-car use Cigarette lighter is not powered when ignition is off. [. . . ]