User manual PHILIPS AX5012

[. . . ] Use only the Philips AY 3767 cord remote control with your CD-player. the buttons on the remote control have the same functions as the corresponding buttons on the CD-player. 1 If necessary, press 9 once or twice until the set is switched off, 2 Firmly plug the remote control into the LINE OUT/p socket of the CD-player, and then connect the headphones to the socket of the remote control. This set complies with the radio interference requirements of the European Community. [. . . ] While the CD is read, 1 -:- flashes in the display. Bass adjustment You can choose between the bass enhancement levels dbb1 and dbb2. 1 Press BASS once for dbb1 and twice for dbb2. y dbb1 or dbb2 is displayed and is shown. 2 To switch dbb1 or dbb2 off, press BASS twice or once, respectively. Briefly press or § once or several times to skip to the current, previous or next track. Y Playback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. Y Searching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. ⷠTo return to normal playback, press MODE repeatedly until the display shows no active modes. You can interrupt playback and continue (even after an extended period of time) from the position where playback stopped (RESUME) and you can lock all buttons of the set so that no action will be executed (HOLD). Use the RESUME­HOLD­OFF slider for these functions. RESUME ­ continuing from where you have stopped 1 Switch the slider to RESUME during playback to activate RESUME. Y RESUME is shown and playback continues from where you have stopped. Now, when a key is pressed, no action will be executed. This is of use, for example, when transporting the player in a bag. With HOLD activated, you can avoid accidental activation of other functions. HOLD is shown when you press any button. If the set is switched off, HOLD will be shown only when 2; is pressed. Note: If you deactivate HOLD by switching the slider to RESUME, you will be activating the RESUME function. [. . . ] Temperature inside the car is too high/low. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. If a fault occurs, first check the points listed, before taking the set for repair. The benefits given to the purchaser by this warranty are in addition to all other rights and remedies which the purchaser has in respect of the product under the Trade Practices Act or other Commonwealth or State Law. [. . . ]