User manual PHILIPS AX5017

[. . . ] skips and searches CD tracks backwards 2; . Switches the player on, starts or pauses CD play § . This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds . 5 mm headphone socket, socket to connect the player to another audio input of an additional appliance, remote control socket (not on all versions) VOL E . [. . . ] battery full Battery two-thirds full Battery one-third full Battery dead or empty. 6 Press 9 again to switch the player off. ⷠTo remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: LINE OUT/p can also be used for connecting the player to your HiFi system (with a signal lead) or to your car radio (with a cassette adapter or signal lead). In both cases, the volume of the player must be set to position 8. Hearing safety: Do not play your headphones at a high volume. Hearing experts advise that continuous use at high volume can permanently damage your hearing. Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard and it is illegal in many countries. Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you. Note: If there is no activity, the set will automatically switch off after a while to save energy. Selecting different playing possibilities-MODE It is possible to play tracks in random order, to repeat a single track or the entire CD, and to play the first few seconds of each track. 1 Press MODE during playback as often as required in B order to activate one of the following `modes'. the active mode is shown in the display. Yshuffle : All tracks of the CD are played in random order until all of them have been played once. Yshuffle repeat all : All tracks of the CD are played repeatedly in random order. Yrepeat : The current track is played repeatedly. Yrepeat all : The entire CD is played repeatedly. YSCAN: The first 10 seconds of each of the shuffle repeat all remaining tracks are played in sequence. 2 Playback starts in the chosen mode after 2 seconds. ⷠTo return to normal playback, press MODE repeatedly until the display shows no active modes. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. [. . . ] Yprogram lights up; the track number programmed and P with the total number of stored tracks are displayed. RESUME and HOLD You can interrupt playback and continue (even after an extended period of time) from the position where playback stopped (RESUME) and you can lock all buttons of the set so that no action will be executed (HOLD). Use the RESUME­HOLD­OFF slider for these functions. RESUME ­ continuing from where you have stopped 1 Switch the slider to RESUME during playback to activate RESUME. [. . . ]