User manual PHILIPS AX5018

[. . . ] Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. [. . . ] Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment. Batteries (supplied or optionally available) You can use the following batteries with this CD-player: · alkaline batteries type AAA (LR03, UM4) or AA (LR6, UM3) preferably Philips). Notes:­ Old and new or different types of batteries should not be combined. ­ Remove batteries if they are empty or if the player is not going to be used for a long time. Inserting AAA (LR03, UM4) batteries 1 Open the AAA battery door. 2 Insert AAA batteries as shown onto the back of the door. 3 Replace the battery-loaded AAA door back onto the set. Inserting AA (LR6, UM3) batteries To double playback time, insert AA batteries into the battery compartment and use the AA marked battery door. · Open the battery compartment and insert either 2 normal or alkaline batteries. + LR03 /AA A /U M4 CD player and CD handling · Do not touch the lens A of the CD player. · Do not expose the unit, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). · You can clean the CD player with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. ­ In shuffle, shuffle repeat all or repeat mode (see MODE chapter), or while playing a program, searching is only possible within the particular track. · Always remove the voltage converter from the cigarette lighter jackwhen the set is not in use. Note: If your car radio has a LINE IN jack, it is better to use it for the car radio connection instead of the cassette. adapter. Connect the signal lead to this LINE IN jack and to LINE OUT/p on the set. p Playing a CD This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. 1 Push the OPEN 2 slider to open the player. 2 Insert an audio CD, printed side up, by pressing the CD onto the hub. 3 Close the player by pressing the lid down. 4 Press 2; to switch the player on and start playback. yThe current track number and elapsed playing time are displayed. · You can pause playback by pressing 2;. [. . . ] 2 Playback starts in the chosen mode after 2 seconds. · To return to normal playback, press MODE repeatedly until the display shows no active modes. ESP / Power Save Mode With a conventional portable CD-player you might have experienced that the music stopped e. g. The ELECTRONIC SKIP PROTECTION prevents loss of sound caused by light vibrations and shocks. [. . . ]