User manual PHILIPS AX5123

[. . . ] Do not expose the unit, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). You can clean the CD player with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. To clean the CD, wipe it in a straight line from the center toward the edge using a soft, lint-free cloth. [. . . ] This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds 0 VOL +/- . This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. YThe current track number and elapsed playing time are displayed. YThe time at which playback was paused starts flashing. YThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. To remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: If there is no activity, the set will automatically switch off after a while to save energy. WARNING: Under no circumstances should you try to repair the set yourself as this will invalidate the warranty. If a fault occurs, first check the points listed, before taking the unit for repair. 1 While playback is stopped, select a track with or §. Yprogram lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROGRAM for more than 2 seconds. yThe display shows all the stored tracks in sequence. Notes: ­ If you press PROGRAM and there is no track selected, SEL is displayed. ­ If you try to store more than 30 tracks, FULL is displayed. clearing the program · While playback is stopped, press 9 to clear program. Y CLRis displayed once, program goes off, and the program is cleared. RESUME and HOLD You can interrupt playback and continue (even after an extended period of time) from the position where playback stopped (RESUME) and you can lock all buttons of the set so that no action will be executed (HOLD). Use the OFF­RESUME­HOLD slider for these functions. RESUME ­ continuing from where you have stopped 1 Switch the slider to RESUME during playback to activate RESUME. [. . . ] inserting AAA (LR03 , UM4) or AY 3363 batteries 1 Open the AAA battery door. 2 Insert AAA batteries as shown onto the back of the door. 3 Replace the battery-loaded AAA door back onto the set. Inserting AA (LR6, UM3) batteries To double playback time, insert AA batteries into the battery compartment and use the AA marked battery door. [. . . ]