User manual PHILIPS AX5210/07B

[. . . ] Portable CD Player Audio AX5200 AX5204 AX5208 AX5201 AX5205 AX5209 AX5202 AX5206 AX5210 AX5203 AX5207 6 7 8 5 4 2 3 9 0 % $ !# 1 + - - + @ ^ + + - & 1 QUICK START MISE EN SERVICE RAPIDE p 1 + 1. - -+ 2. + - + + 3 # 4 HOLD OFF 5 PLAY 2; 6 VOL !!! 2 English CONTROLS / POWER SUPPLY POWER SUPPLY / GENERAL INFORMATION Average playing time of batteries under normal conditions Battery type ESP on Power Save Normal AA 5 hours 9 hours Normal AAA 3 hours 5 hours Alkaline AA 18 hours 33 hours Alkaline AAA 8 hours 15 hours Rechargeable ECO-PLUS NiMH battery 7 hours 12 hours Batteries contain chemical substances, so they should be disposed of properly. ECO-PLUS NiMH battery information (for versions supplied with the rechargeable ECO-PLUS NiMH battery AY 3363) Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3363. [. . . ] 3 Close the player by pressing the lid down. 4 Press 2; to switch the player on and start playback. yThe current track number and elapsed playing time are displayed. · You can pause playback by pressing 2;. yThe time at which playback was paused starts flashing. · You can continue playback by pressing 2; again. yThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. · To remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: If there is no activity, the set will automatically switch off after a while to save energy. In-car use (connections supplied or optionally available) Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltage converter (4. 5 V DC, positive pole to the centre pin) and the AY 3501 car cassette adapter. 1 Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4. 5V DC input socket on the set. 12 V DC Playback information · If a CD-Recordable (CD-R) or a CD-Rewritable (CDRW) is not recorded properly, NF dISC is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. · When playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. · Playback will stop if you open the CD lid. · While the CD is read, 1 -:- flashes in the display. Volume and bass Volume adjustment · Adjust the volume by using VOL +/-. 2 4, 5 V DC 3 4 5 6 7 If necessary, clean the cigarette lighter socket to obtain a good electrical contact. Turn down the volume and connect the cassette adapter plug to LINE OUT/p on the set. Carefully insert the cassette adapter into the car radio's cassette compartment. Make sure the cord does not hinder your driving. Decrease the volume on the set if necessary. [. . . ] 1 Switch the slider to HOLD to activate HOLD. yAll buttons are locked HOLd is shown when you press any button. If the set is switched off, HOLd will be shown only when 2; is pressed. 2 To deactivate HOLD, switch the slider to OFF. [. . . ]