User manual PHILIPS AX7104

[. . . ] Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it. ⷠTo avoid a short circuit, do not let the battery touch any metal object. ⷠIf the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime. [. . . ] Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4. If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded properly, nF dISC is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. ⷠWhen playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. While the CD is read, 1 -:- flashes in the display. If necessary, clean the cigarette lighter socket to obtain a good electrical contact. turn down the volume and connect the adapter cassette plug to LINE OUT/p on the set. Carefully insert the adapter cassette into the car radio's cassette compartment. Make sure the cord does not hinder your driving. Always remove the voltage converter from the cigarette lighter socket when the set is not in use. Note: If your car radio has a LINE IN socket, it is better to use it for the car radio connection instead of the adapter cassette. Connect the signal lead to this LINE IN socket and to LINE OUT/p on the set. Selecting a track and searching Selecting a track during playback · Briefly press or § once or several times to skip to the current, previous or next track. YPlayback continues with the selected track, and the track's number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times to select the desired track. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. YSearching starts while playback continues at low volume. 2 Release the button when you reach the desired passage. Selecting different playing possibilities-MODE It is possible to play tracks in random order, to repeat a single track or the entire CD, and to play the first few seconds of each track. 1 Press MODE during playback as often as required in order to activate one of the following `modes'. the active mode is shown in the display. [. . . ] If you are unable to solve a problem by following these hints, consult your dealer or service center. The CD player has no power, or playback does not start · Check that your batteries are not dead or empty, that they are inserted correctly, that the contact pins are clean. ⷠYour adapter connection may be loose. If your lens has steamed up, wait a few minutes for this to clear. [. . . ]