User manual PHILIPS AZ1010

[. . . ] Selects the different CD playing modes and programs tracks 8 Display Remove batteries if they are flat or if the set is not going to be used for a long time. 1 Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organisation. the type plate is located on the bottom of the set. [. . . ] TM REPEAT ALL: The entire CD (or program) is played repeatedly. 2 After 2 seconds of flashing display indication, CD play starts in the chosen mode. 3 To return to normal CD play, press CD MODE until the display indication disappears. You can select a number of tracks and store these in the memory in the desired sequence. a maximum of 20 tracks can be stored in the memory. 1 When CD play is stopped, select the desired track with or §. 2 As soon as the number of the desired track is displayed, press CD MODE to store the track in the memory. P lights up briefly, then the number of the stored track is shown. 3 Select and store all desired tracks in this way. 4 You can review your settings by pressing and holding CD MODE for more than 1 second. TM The display shows all stored track numbers in sequence. If you try to store more than 20 tracks, the display shows F. TM no lights up briefly, PROGRAM disappears and your program is erased. Note: The program will also be erased if you: ­ interrupt the power supply, ­ open the CD compartment, or ­ move the POWER slider. 3 Insert a recorded cassette with the open side upwards and close the cassette compartment. Recording is permissible insofar as copyright or other rights of third parties are not infringed upon. For recording on this set you should use a cassette of the type NORMAL (IEC type I). This deck is not suitable for recording on cassettes of the type CHROME (IEC type II) or METAL (IEC type IV). [. . . ] If you are unable to solve a problem by following these hints, consult your dealer or service center. No sound, no power Trying to change over from mains to battery supply without removing the plug. Disconnect the set from power supply, reconnect after a few seconds. direct the antenna for optimum reception. [. . . ]