User manual PHILIPS AZ1010-11H

[. . . ] 2 If the set is equipped with a VOLTAGE selector A, set this selector to the local mains voltage. To change over to battery supply, pull out the plug from the unit's AC MAINS socket. To disconnect the set from the mains completely, remove the mains plug from the wall socket. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). [. . . ] For MW stations, direct the built-in antenna by turning the whole set. You can interrupt CD play by pressing 2;. Note: CD play will also stop if: ­ you open the CD compartment, ­ the end of the CD is reached, or ­ you move the POWER slider. If you make a mistake when operating the CD player, or if the CD player cannot read the CD, the display shows E or no. ) If you press 2; and there is no CD inserted, the display shows no. Search backward and forward § Selecting another track Briefly press the or § button once/several times to skip to the beginning of the current, previous or subsequent track(s). During CD play: CD play continues automatically with the selected track. When CD play is stopped: Press 2; to start CD play. tM Display indication: the selected track number. Searching for a passage during CD play 1 Hold down the or § button to find a particular passage in a forward or backward direction. Note: In the different CD modes or when playing a program, searching is only possible within the particular track. Now, recording on this side is no longer possible. To record again on this side of the cassette, cover the opening with a piece of adhesive tape. Note: the recording can be started from different positions: ­ if the CD player is in pause mode, recording will start from this very position (use or §); ­ if the CD player is in stop mode, recording will start from the beginning of the CD or program. Recording from the CD player ­ CD synchro start Do not expose the set, batteries, CDs, or tapes to humidity, rain, sand, or excessive heat (caused by heating equipment or direct sunlight). The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated!You can clean the set with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. To ensure proper recording and playback quality, clean parts A, B and C after approximately 50 hours of operation. Use a cotton swab slightly moistened with alcohol or head-cleaner fluid. Press PLAY 1 and clean the rubber pressure roller A. Press PAUSE ; and clean the capstan B and the heads C. [. . . ] Always pick up the CD by the edge and put it back in its box after use. To clean the CD, wipe it in a straight line from the center toward the edge using a soft, lint-free cloth. This set complies with the radio interference requirements of the European Community Under no circumstance should you try to repair the set yourself as this will invalidate the guarantee. If a fault occurs, first check the points listed below before taking the set for repair. [. . . ]