User manual PHILIPS AZ1016

[. . . ] 45 dB Channel separation . . . . . . . . . . . . . . . . . . . . . . . . 40 DB (1 KHz) Harmonic distortion. . . . . . . . . . . . < 1%(10 KHz, -20 dB) Specifications are subject to change TAPE DECK Frequency response PB . . . . . . . . . . . . . . . . . . . 125Hz-8000Hz Signal-to-noise ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Make sure you remove the plug from the set and wall outlet before inserting batteries. Batteries (not included) 1 Open the battery compartment and insert 6 batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "­" symbols inside the compartment. (See 2) Replace the compartment door, making sure the batteries are firmly and correctly in place. Batteries contain chemical substances, so they should be disposed of properly. 2 3 4 · 2 CD Player Playing a CD This CD player plays Audio Discs including CD-Recordables (CD-R) and CDRewritables (CD-RW). MP3, CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible for playback. Open the CD door, and insert a CD with the printed side facing up and press the CD door gently close. Display shows -- and later, the total number of tracks. (See 3) Press 2/; PLAY/PAUSE to start playback. (See 4) To resume, press 2/; again To stop CD playback, press 9. CD Player/Cassette Recorder Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1 In the stop position, press PROG to activate programming. (See 5) Press or § to select your desired track number. Press PROG to store the desired track number. Display: PROG and 00 flash for you to program the next track. . Repeat steps 2 to 3 to select and store all desired tracks in this way. If you attempt to store more than 20 tracks, no track can be selected and the display shows --. To play your program, press 2/;. Cassette Recorder · General information on recording Recording is permissible insofar as copyright or. other rights of third parties are not infringed. For recording, use only NORMAL type cassettes (IEC type I) on which the tabs have not yet been broken. This deck is not suited for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. The best recording level is set automatically. Altering the VOLUME or BASS BOOST will not affect the recording. To protect a tape from accidental erasure, break out the tabs. [. . . ] The lens of the CD player should never be touched!Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. Always close the CD-tape door to avoid dust on the lens. [. . . ]