User manual PHILIPS AZ1019

[. . . ] Listen for reasonable periods of time: Prolonged exposure to sound, even at normally "safe" levels, can also cause hearing loss. Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for reasonable periods of time. [. . . ] · For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. 2 3 4 · CD Player Playing a CD This CD player plays Audio Discs including CD-Recordables (CD-R). · CD-Rewritables (CD-RWs), MP3 CD-ROMs, CD-I, CDV, VCD, DVD or computer CDs are not possible for playback. CDs encoded with copyright protection technologies by some record companies may be unplayable by this product. Open the CD door, and insert a CD/ CD-R with the printed side facing up and press the CD door gently close. Display shows -- and later, the total number of tracks. (See 3) Press 2; on the set to start playback. To stop CD playback, press 9. Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1 In the stop position, press PROG to activate programming. (See 5) Press or § to select your desired track number. Press PROG to store the desired track number. Display: PROG and 00 flashes for you to program the next track. . Repeat steps 2 to 3 to select and store all desired tracks in this way. If you attempt to store more than 20 tracks, no track can be selected and the display shows --. To play your program, press 2;. · 1 2 2 3 3 4 5 6 4 Helpful hints : CD play will also stop when: 5 ­ you open the CD compartment; ­ you select RADIO or TAPE/ OFF sound source; ­ the CD has reached the end. Helpful hints : ­ When playback of your program comes to the stop position, your set will return to normal playback. To re-enter program mode, press PROG in the stop position. Selecting a different track · Press or § once or repeatedly until the desired track number appears in the display. · In the pause/stop position, press 2; to start playback. Reviewing the program In the stop position, press PROG repeatedly to see your stored tracks. Erasing a program Finding a passage within a track During playback, press and hold or § . 2 When you recognize the passage you want, release or § to resume normal playback. 1 Helpful hints : When searching within a final track and you reach the end of the last track, the CD goes to stop mode. You can erase the contents of the memory by: ­ selecting TAPE/ OFF or RADIO sound source; ­ opening the CD door; ­ in the stop position, press PROG to enter program mode and then, press 9. CD /Cassette Recorder Different play modes: REP. A (See 6, 7) You can select and change the play modes before or during playback, and combine the modes with PROG. ­ plays the current track continuously. [. . . ] No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair. [. . . ]