User manual PHILIPS AZ1021N

[. . . ] (See 2) Replace the battery door, making sure the batteries are firmly and correctly in place. The set is now ready to operate. Batteries contain chemical substances, so they should be disposed of properly. Incorrect use of batteries can cause electrolyte leakage and corrode the compartment or cause the batteries to burst: Do not mix battery types: e. g. Only use batteries of the same type for the set. [. . . ] Repeat steps 2 to 3 to select and store all desired tracks in this way. If you attempt to store more than 20 tracks, no track can be selected and the display shows --. and SHUFFLE (See 6, 7) REPEAT You can play the current track or the whole disc repeatedly, and combine REPEAT modes with PROG (PROGRAM). REP ­ plays the current track continuously. REP ALL ­ repeats the entire CD/program To select play mode, press REPEAT once or more. The display shows REP icon or REP ALL icon. Press 2; to start playback in the stop/pause position. To return to normal playback, press REPEAT repeatedly until the modes are no longer displayed. ­ You can also press 9 to cancel your play mode. SHUFFLE You can play all the tracks in random order. 1 In the stop position, press SHUFFLE to switch on shuffle play. To switch off shuffle play, press 9. 2 3 2 3 4 5 Helpful hints : ­ When playback of your program comes to the stop position, your set returns to normal playback. To re-enter program mode, press PROG in the stop position. 2 Reviewing the program In the stop position, press PROG repeatedly to see your stored tracks. Erasing a program You can erase the contents of the memory by: ­ in the stop position, press PROG to enter program mode, and then press 9. ­ selecting TUNER or OFF; ­ opening the CD door; Helpful hints: ­ During the shuffle play, when REP function is selected, the set plays the current shuffled track repeatedly, or when the REP ALL function is selected, it repeats the shuffle play of the entire CD. Maintenance & Safety · (See 8) Safety information · · Place the set on a flat, hard and stable surface so that the system does not tilt. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable. Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. The apparatus shall not be exposed to dripping or splashing. Adequate ventilation with a minimum gap of 15cm (6 inches) between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. Do not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. CD player and CD handling If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair. [. . . ] The guarantee applies only to faults caused by defective components, or faulty workmanship on the part of the manufacturer. The guarantee does not cover failures caused by misuse, neglect, normal wear and tear, accidental breakage, use onthe incorrect voltage, use contrary to operating instructions, or unauthorised modification to the product or repair by an unauthorised technician. Reasonable evidence (in the form of a sales docket) must be supplied to indicate that the product was purchased no more than 12 months prior to the date of your claim. In the event of a failure, Philips shall be under no liability for any injury, or any loss or damage caused to property or products other than the product under guarantee. [. . . ]