User manual PHILIPS AZ102B

[. . . ] · Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Recording and playback of material may require consent. See Copyright Act 1956 and The Performer's Protection Acts 1958 to 1972. AZ102_05_ENG_CCR 2010. 3. 30 15:14 Page 6 English Congratulations on your purchase, and welcome to Philips! [. . . ] Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit. The type plate is located on the bottom of the set. Helpful hints: ­ To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set. General Operation / Tuner General operation Switching on and off and selecting the function To select your sound source, adjust the Source selector to: CD, FM or MW. To switch off the set, adjust the Source selector to OFF position. To switch to LINE IN mode, connect an external audio source to the LINE-IN inlet. 1 2 3 Helpful hints: · The set switches to LINE IN mode automatically when an external audio source is connected, no matter the set is in CD, FM or MW mode. Adjusting volume and sound Adjust the sound with the VOLUME and DBB controls. · 2 3 4 · Radio reception 1 2 Adjust the Source selector to FM or MW. Turn TUNING to tune to a station. Helpful hints: To improve radio reception · For FM, extend, incline and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set. · AZ102_05_ENG_CCR 2010. 3. 30 15:14 Page 8 CD Player Playing a CD · This CD player plays Audio Discs including CD-Recordables (CD-R) and CD-Rewritables (CD-RW). MP3, CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible for playback. CDs encoded with copyright protection technologies by some record companies may be unplayable by this product. Open the CD door, and insert a CD with the printed side facing up, then press the CD door gently to close. Display shows --, and later the total number of tracks. (See 3) 3 4 5 6 Press 2; to start playback. To stop CD playback, press 9. Selecting a different track · Press / § once or repeatedly until the desired track number appears in the display. · In the pause/stop position, press 2; to start playback. · IMPORTANT!1 Finding a passage within a track During playback, press and hold or § . The CD is played at high speed and with reduced volume. When you recognize the passage you want, release or § to resume normal playback. 2 Helpful hints: ­ When your searching reaches the end of the last track, the CD goes to stop mode. Helpful hints: CD play will also stop when: ­ you open the CD door; ­ you select FM, MW or OFF sound source; ­ the CD has reached the end. AZ102_05_ENG_CCR 2010. 3. 30 15:14 Page 9 CD Player Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. [. . . ] The lens of the CD player should never be touched!Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. Always close the CD door to avoid dust on the lens. [. . . ]