User manual PHILIPS AZ1031

[. . . ] Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Recording and playback of material may require consent. See Copyright Act 1956 and The Performer's Protection Acts 1958 to 1972. 4 PLAY 5 X PROG 6 REP. PLAY 7 REP. A PLAY C B A A 1 2 ^ 53 60 70 80 88 92 96 100 104 106 107 108 MHz OFF 100 120 & FM 3 2 CD TAPE TUNER 140 160 x10 kHz BASS BOOST OFF ON MW BAND MW FM FM ST. 4 5 6 7 * ( 6xR14·UM-2·C-CELLS VOLUME TUNING % LIF CD RAD IO CASSETT E ER T TO 31 CO RD OPE 1 Z R 10 E N A REPEAT $ # @ PLAY/ PAUSE STOP POWER FM ST. 8 9 0 ! PROG NEXT PREVIOUS English Supplied Accessories ­ AC power cord Controls/Power Supply Back panel (See 2) ^ Telescopic antenna - improves FM reception. [. . . ] 2 3 · 2 CD Player Playing a CD This CD player plays Audio Discs including CD-Recordables (CD-R) and CDRewritables (CD-RW). · 1 2 MP3, CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible for playback. Open the CD door, and insert a CD with the printed side facing up, then press the CD door gently to close. Display shows --, and later the total number of tracks. (See 3) 3 4 5 6 Press 2 PLAY / ; PAUSE to start playback. (See 4) To resume, press 2/; again To stop CD playback, press 9. 5 4 2 3 1 CD Player Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. In the stop position, press PROG to activate programming. (See 5) Press or § to select your desired track number. Press PROG to store the desired track number. Display: PROG and 00 flash for you to program the next track. . Repeat steps 2 to 3 to select and store all desired tracks in this way. If you attempt to store more than 20 tracks, no track can be selected and the display shows --. To play your program, press 2/;. Cassette Recorder General information on recording · Recording is permissible insofar as copyright or. other rights of third parties are not infringed. For recording, use only NORMAL type cassettes (IEC type I) on which the tabs have not yet been broken. This deck is not suited for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. The best recording level is set automatically. Altering the VOLUME or BASS BOOST will not affect the recording. To protect a tape from accidental erasure, break out the tabs. If you wish to record again, cover the tabs with a piece of adhesive tape. Recording from the CD Player 1 2 3 Select CD source. [. . . ] Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. Always close the CD-tape door to avoid dust on the lens. Press PAUSE and clean the heads A, and the capstan B. After cleaning, press STOP·EJECT. [. . . ]