User manual PHILIPS AZ1081

[. . . ] AZ1080/00A 03/13/02 10:06 Page 1 CD Soundmachine Audio 1080 AZ 1081 AZ AZ1080/00A 03/13/02 10:06 Page 2 Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. [. . . ] Direct the aerial by turning the whole set. 3 To switch off the radio, adjust the source selector to TAPE/OFF position and check the cassette keys are released. 1 Adjust the source selector to CD. 2 To open the CD door, lift the CD door at the edge marked LIFT TO OPEN. 3 Insert a CD or CD-(R) with the printed side facing up and press the CD door gently close. 4 Press PLAY·PAUSE 2; on the set to start playback. 5 To pause playback press PLAY·PAUSE 2;. To resume, press PLAY·PAUSE 2; again. 2 flashes during pause 6 To stop CD play, press STOP 9. 7 To switch off the set, adjust the source selector to TAPE/OFF position and check the cassette keys are released. For recording, use only NORMAL type cassettes (IEC type I) on which the tabs have not been broken. · The best recording level is set automatically. Altering the VOLUME and DBB controls will not affect the recording in progress. · At the very beginning and end of the tape, no recording will take place during the 7 seconds when the leader tape passes the recorder heads. · To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. To record over this side again, cover the tabs with a piece of adhesive tape. Synchro Start CD recording CD SOUN 1 Adjust the source selector to TAPE/OFF. 2 Press STOP·OPEN 9/ to open the cassette door and insert a recorded cassette. 5 To pause playback press PAUSE ;. To resume, press the key again. 6 By pressing SEARCH 5 or 6, fast winding of the tape is possible in both directions. To stop fast winding, press STOP·OPEN 9/. 7 To stop the tape, press STOP·OPEN 9/. · The keys are automatically released at the end of the tape, and the set is switched off, except if PAUSE ; has been activated. LI F T TUNING LIFT T O O PE N CD MW FM TAP F OF SEAR CH PAUS SEAR CH PLAY TO OPE N Y/ PAUSE PLA SEARCH DY AMI N C BASS BOO S DBB 1 Select CD source. 3 Press STOP·OPEN 9/ to open the cassette door. Insert a blank tape. RE T AZ1080HINE DMAC WRITABLE COM PATIBLE CD RE E STOP · OPEN VOL UM E CK CD TRA ST O P REPEAT SHUFFLE T PEA T AZ1080/00A 03/13/02 10:06 Page 11 Recording 5 Press RECORD 0 to start recording. [. . . ] CD player and CD handling · The lens of the CD player should never be touched!· Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. · Always close the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth. [. . . ]