User manual PHILIPS AZ1110

[. . . ] environmental information All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene (buffer), polyethylene (bags, protective foam). Your set consists of materials which can be recycled if disassembled by a specialized company. Whenever convenient, use the mains supply if you want to conserve battery life. [. . . ] Repeat step 3 if necessary until you find the desired station. ⷠTo tune to a weak station, press SEARCH or § briefly and repeatedly until you have found optimal reception. Adjust the power slider to TAPE/OFF position to switch off the set. Reduce its length if the signal is too strong (very close to a transmitter). ­ For MW/LW, the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. Favourite station selection For your favourite 3 tuner stations, you can use the easy one-touch programming and selection 1, 2 or 3 buttons. To store your station, press 1, 2 or 3 for 2 seconds or more. TM Display: shows PROGRAM briefly, your favorite preset station number and the tuner frequency. Press PRESET 4 or 3 once or more to allocate a number from 1 to 30 to this station. ­ Display: PROGRAM disappears, the preset number and the frequency of the preset station are shown. Use the SEARCH or § on the set, to select your desired track number. TM If you attempt to programme without first selecting a track number, is shown. TM is displayed if you attempt to programme more than 20 tracks. In the STOP position, press and hold down PROGRAM for a while until the display shows all your stored track numbers in sequence. Erasing a programme You can erase the programme by: ­ pressing STOP 9 once in the STOP position or twice during playback. If the CD player cannot read CDs correctly, use a commonly available cleaning CD to clean the lens before taking the set to repair. Other cleaning methods may destroy the lens. ⷠThe lens of the CD player should never be touched! ⷠSudden changes in the surrounding temperature can cause condensation to cloud over on the lens of your CD player. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. ⷠAlways keep the CD compartment closed to avoid dust on the lens. [. . . ] If you are recording from MW/LW stations, adjust the BEAT CUT switch to eliminate possible whistle tones during recording. MAINTENANCE Tape deck maintenance To ensure quality recording and playback of the tape deck, clean parts A, B and C shown in the diagram below, after approx. 50 hours of operation, or on average once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. [. . . ]