User manual PHILIPS AZ1110/11H

[. . . ] Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment. Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall socket before inserting batteries. Open the battery compartment and insert six batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. [. . . ] ­ For MW, the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. To switch off the radio, adjust the source selector to the OFF/ TAPE position (with the cassette keys released). CD PLAYER Display indication for CD functions: ­ Total track number: in stop mode ­ Current track number: during CD play ­ Current track number flashes when on PAUSE ­ SHUFFLE/ REPEAT: modes: when the respective mode is activated ­ PROGRAM: when active: P also appears briefly when you store a track ­ no: no disc/ error in CD operation or with the CD (see Troubleshooting) ­ F: programme memory full Playing a CD 1. ­ The CD player scans the contents of the CD and the total number of tracks is shown. To switch off the set, adjust the source selector to the OFF/ TAPE position (with the cassette keys released). Selecting a different track During playback, you can use the SEARCH keys to select a particular track. ­ If you have selected a track number in the stop or pause position, press PLAY· Press SEARCH § once for the next track, or press repeatedly until the desired track number appears in the display. Press SEARCH once to return to the beginning of a current track. Press SEARCH more than once for a previous track. ­ The CD is played at high speed and low volume. To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. To record over this side again, cover the tabs with a piece of adhesive tape. ­ Playing of the CD programme starts automatically from the beginning of the programme. It is not necessary to start the CD player separately. To select and record a particular passage During CD playback, press and hold down the SEARCH buttons or § to find your passage. PAUSE 2; to put the CD player on pause at the selected passage. ­ Recording will begin from this exact point in the track when you press RECORD 0. Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. Adequate ventilation with a minimum gap of 15 cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. [. . . ] Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. To take a CD out of its box, press the centre spindle while lifting the CD. Always pick up the CD by the edge and replace the CD back in its box after use to avoid scratching and dust. To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. [. . . ]