User manual PHILIPS AZ1201

[. . . ] Return your Warranty Registration card today to ensure you receive all the benefits you're entitled to. Once your Philips Magnavox purchase is registered, you're eligible to receive all the privileges of owning a Philips Magnavox product. So complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. [. . . ] This device must accept any interference received, including interference that may cause undesired operation. The set is switched off when the POWER control is set to O F F/TAPE and the keys of the tape deck are released. Note: If you use batteries, always be sure to switch the set off after use. This will avoid unnecessary power consumption. The bass level can also be emphasized if you place the set against a wall or shelf. Do not cover any vents; leave sufficient room around the unit for ventilation. Reduce its length if the signal is too strong (very close to a transmitter). For AM stations, direct the built-in antenna by turning the whole set. You can interrupt CD play by pressing PLAY· Note: CD play will also stop if: ­ you open the CD compartment, ­ the end of the CD is reached, or ­ you move the POWER control to TUNER or TAPE. If you make a mistake when operating the CD player, or if the CD player cannot read the CD, the display shows E or no. PAUSE 2; and there is no CD inserted, the display shows no. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment. SHUFFLE ­ Playing in random order 1 Press SHUFFLE before or during CD play. TM All the tracks of the CD (or program if available) will now be played in random order. 2 Press SHUFFLE again to return to normal CD play. REPEAT ­ Repeating the entire CD or one track of the CD 1 Before or during CD play, press REPEAT repeatedly to cause the display to show the different repeating modes. TM REPEAT: the current track is played repeatedly. TM REPEAT ALL: the entire CD or program is played repeatedly. 2 Press REPEAT until the display indication disappears to return to normal CD play. Note: You can activate the different playing modes at the same time, e. [. . . ] Leave the CD player in a warm environment until the moisture evaporates. To take the CD out of its box easily, press the center spindle while lifting the CD. Reception problems caused by signal conditions or cable or antenna systems outside the unit. A product that requires modification or adaptation to enable it to operate in any country other than the country for which it was designed, manufactured, approved and/or authorized, or repair of products damaged by these modifications. [. . . ]