User manual PHILIPS AZ1202

[. . . ] 9 PROG ­ programs tracks and reviews the program 0 REPEAT ­ repeats a track/program/the entire CD. DBB (Dynamic Bass Boost) ­ turns the bass enhancement on/off. @ VOLUME ­ adjusts volume level # CD Display ­ shows CD functions 3 · Back panel ^ Telescopic antenna - improves FM reception. & Headphone - 3. 5mm stereo headphone jack * Battery door - open to insert 6 x 1. 5V R-14/ UM2/ C-cells. [. . . ] (See 3) To pause playback, · Press 2;. To resume playback, · Press 2; again. 2 1 Selecting a different track During playback, · Briefly press SEARCH or § once or repeatedly until you find your desired track. During stop or pause, · Press 2; to start playback after your desire track is selected. Helpful hints: · To improve reception For FM, extend, incline and turn the telescopic antenna. Reduce its length if the signal is too strong. Direct this antenna by turning the whole set. Finding a passage within a track During playback, press and hold down or §. The CD is played at high speed and low volume. When you recognize the passage you want release or §. Normal playback resumes. 4 · Helpful hints: ­ When your searching reaches the end of the last track, the CD playback stops. Helpful hints: The CD playback will also stop when: ­ you open the CD compartment; ­ you select RADIO or TAPE sound source; ­ the CD has reached the end of the playback. CD Player Programming tracks You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1 In the STOP position, press PROG to start programming. Press 9/ to stop rewinding/fast forwarding. 1 2 3 4 · Select CD source. Insert a CD and if desired, program track numbers. Playing of the CD programme starts automatically from the beginning of the programme. You don't need to start the CD player separately. To stop recording, Press 9/. · · · Cassette Recorder Recording from the Radio 1 2 3 Adjust the source selector to LW, MW or FM as desired. Tune to a desired radio station (See Radio reception) Follows steps 3-4, under Recording from the CD. · Maintenance Precautions & General Maintenance (See 7) · · Place the set on a hard and flat surface so that the system does not tilt. Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. Adequate ventilation with a minimum gap of 6 inches between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. Maintenance CD player and CD handling (See 7) · If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair. [. . . ] Note:The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · Connect the blue wire to the terminal marked N or coloured black. · Connect the brown wire to the terminal marked L or coloured red. [. . . ]