User manual PHILIPS AZ1203

[. . . ] Open the battery compartment and insert six batteries, type R-20, UM-4 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. Replace the compartment door, making sure the batteries are firmly and correctly in place. ­ If BATT LOW lights up, battery power is running low. ­ The BATT LOW indicator eventually goes out if the batteries are too weak. [. . . ] Press BAND once or more to select your waveband. Reduce its length if the signal is too strong (very close to a transmitter). ⷠFor MW and LW, the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. The total number of tracks and playing time are then shown. TM Display: Current track number and elapsed playing time of the track during CD playback. TM The display freezes and the elapsed playing time flashes when playback is paused. Note: CD playback will also stop when: ­ the CD door is opened; ­ the CD has reached the end (unless you have selected REPEAT ALL); ­ you select another source: TAPE / TUNER. Press SEARCH or § once or repeatedly until the desired track number appears in the display. ⷠIf you have selected a track number shortly after loading a CD or in the PAUSE position, you will need to press PLAY· Finding a passage within a track ­ The CD is played at high speed and low volume. When you recognize the passage you want, release SEARCH or §. Recording on this side is no longer possible. To record over this side again, cover the tabs with a piece of adhesive tape. Insert a suitable tape into the cassette deck and close the cassette door. ­ Playing of the CD programme starts automatically from the beginning of the programme. It is not necessary to start the CD player separately. To select and record a particular passage within a track: · When you recognize the passage you want, release SEARCH or §. Recording will begin from this exact point in the track when you press RECORD 0. Insert a suitable tape into the cassette deck and close the cassette door. Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. ⷠTo clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. [. . . ] To ensure quality recording and playback of the tape deck, clean parts A, B and C shown in the diagram below, after approx. 50 hours of operation, or on average once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean both decks. Press PLAY 1 and clean the rubber pressure rollers C. [. . . ]