User manual PHILIPS AZ1500-00C

[. . . ] Note: The speakers will be muted when headphones are connected to the set. ¡ , TM - skips to the beginning of a current track previous/ subsequent track. REPEAT - repeats a track /program/ entire CD. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. [. . . ] Available stations are programmed in order of waveband reception strength: FM, followed by MW (AM). Press PROGRAM for 4 seconds or more to activate autostore programming. TM The display shows AUtO, PROG blinks, followed by the radio station details when stored. After all stations are stored, the first preset station will then automatically play. to listen to a preset station · Direct Easy Access: use the digit panel on the set to key in a number, 1-40, to select a preset station. Insert a CD with the printed side facing up and close the door. Note : CD play will also stop when: - the CD-tape door is opened - the CD has reached the end - you select TAPE or RADIO function. Selecting a different track There are 2 ways: Key in the number of the track using the digit panel on the set. sEARCH or § · Press SEARCH or § once or repeatedly to select your track. press and hold SEARCH or §. ­ The CD is played at high speed and low volume. When you recognize the passage you want, release or § to resume normal playback. Note : During a CD program or if SHUFFLE/ REPEAT active, searching is only possible within a track. Different play modes: SHUFFLE and REPEAT You can select and change the various play modes before or during playback, and combine the modes with PROGRAM. (See 5) SHUFFLE - tracks of the entire CD/ program are played in random order SHUFFLE REPEAT ALL - to repeat the entire CD/ program continuously in random order REPEAT ALL - repeats the entire CD/ program REPEAT - plays the current track continuously TM Display: FULL if you try to program more than 20 tracks. Reviewing the program In the stop position, press and hold PROGRAM until the display shows all your stored track numbers in sequence. The keys are automatically released at the end of a tape and the set switched off, except if PAUSE ; has been activated. Other rights of third parties are not infringed. ⷠFor recording, use only NORMAL type cassettes (IEC type I) on which the tabs have not yet been broken. This deck is not suited for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. To protect a tape from accidental erasure, break out the tabs. If you wish to record again, cover the tabs with a piece of adhesive tape. [. . . ] Press PAUSE ; and clean the heads A, and the capstan B. If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. [. . . ]