User manual PHILIPS AZ1564

[. . . ] Return your Warranty Registration card today to ensure you receive all the benefits you're entitled to. Once your Philips purchase is registered, you're eligible to receive all the privileges of owning a Philips product. So complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. [. . . ] SHUFFLE ­ plays CD tracks in random order @ SEARCH , § TUNER: - (down, up) tunes to radio stations; CD: - searches back and forward within a track; - skips to the beginning of a current track/ previous/ subsequent track # REPEAT ­ repeats a track / CD program / entire CD $ Display ­ shows the status of the set % REMOTE SENSOR ­ infrared sensor for remote control ^ BAND - selects waveband & TUNER PRESET 4, 3 ­ selects a preset tuner station (down, up) BACK PANEL * p ­ 3. 5 mm headphone jack ( Telescopic antenna ­ improves FM reception ) AC POWER ­ inlet for power cord ¡ Battery door REMOTE CONTROL 1 VOLUME 3, 4 ­ adjusts volume level 2 PRESET 3, 4 (up, down) selects a preset radio station 3 TUNING , § (down, up) tunes to radio stations 4 SHUFFLE ­ to play CD tracks in random order 5 REPEAT ­ repeats a track/ CD program/ entire CD 6 2; ­ starts CD playback/ interrupts CD playback 7 ¡, TM ­ skips to the beginning of a current track/ previous/ subsequent track 8 STOP 9 ­ stops CD playback or erases a CD program 9 SEARCH 5, 6 ­ searches backwards or forwards within a track/CD Whenever convenient, use the AC power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. Open the battery compartment and insert six batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. Replace the compartment door, making sure the batteries are firmly and correctly in place. ­ If BATT LOW lights up, battery power is running low. ­ The BATT LOW indicator eventually goes out if the batteries are too weak. ­ Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. ­ When inserting new batteries, do not try to mix old batteries with the new ones. ­ Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances , so they should be disposed of properly USING AC POWER 1. Check if the power voltage as shown on the type plate located on the bottom of the set, corresponds to your local AC power supply. If it does not, consult your dealer or service center. If your set is equipped with a voltage selector, adjust the selector so that it matches with the local power. Connect the power cord to the wall outlet and the set is now ready for use. To disconnect the set from the power completely, remove the plug from the wall outlet. The set is switched off when the POWER slider is in the TAPE/OFF position and the buttons on the tape deck are released. TM Display shows the volume level indication: on the volume bar, VOL, and a number from 0-32. Note: The effect of INCREDIBLE SURROUND may vary with different types of music. Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. [. . . ] Recording on this side is no longer possible. To record over this side again, cover the tabs with a piece of adhesive tape. Insert a suitable tape into the cassette deck and close the cassette door. ­ Playing of the CD program starts automatically from the beginning of the program. [. . . ]