User manual PHILIPS AZ2725

[. . . ] Make sure you remove the plug from the set and wall outlet before inserting batteries. 8 POWER SUPPLY BATTERIES (OPTIONAL) 1. Open the battery compartment and insert six batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. Replace the compartment door, making sure the batteries are firmly and correctly in place. [. . . ] To open the CD door, press OPEN on the CD door. Insert a CD with the printed side facing up and press the CD door gently to close. Press PLAY/PAUSE 2; on the set to start playback. To interrupt playback press PLAY/PAUSE 2;. Press POWER again to switch off the set. Note: CD playback will also stop when: ­ you press the CD door open; ­ TUNER or TAPE source is pressed; ­ the CD has reached the end. Selecting a different track During playback, you can use the SEARCH buttons to select a particular track. ­ If you have selected a track number in the stop or pause position, press PLAY/PAUSE 2; to start playback. · Press SEARCH TM once briefly for the next track, or press repeatedly until the desired track number appears in the display. · Press SEARCH ¡ once briefly to return to the beginning of a current track. · Press SEARCH ¡ more than once briefly for a previous track. Adjust the sound using the VOLUME and DBB controls 7. By pressing 5 or 6, fast winding of the tape is possible in both directions. To stop fast winding, press STOP/EJECT 9 /. ­ The keys are automatically released at the end of the tape, except if PAUSE ; has been activated. 10. Press POWER again to switch off the set. 14 SHUFFLE CD TUNER TAPE PROG REPEAT STOP SEARCH PLAY/PAUSE FM MHz 88 530 · 92 · MW KHz 96 · 100 · 104 · 108 DECK A RECORD PLAYBAC K RECOR RECOR D PLA D PLA Y Y SEARC SEARC H H STOP/EJ STOP/EJ ECT PAU ECT PAU SE SE CASSETTE RECORDER Continuous Playback 1. Repeat steps 1 - 4 above, but load both decks. Press PLAY 2 on deck 2 and deck 2 will start. Press PAUSE ; on deck 1 and then PLAY 2. As soon as deck 2 stops (end of tape or STOP/EJECT 9 / pressed), PAUSE ; on deck 1 is released and deck 1 will start playback. GENERAL INFORMATION ON RECORDING · Recording is permissible insofar as copyright or other rights of third parties are not infringed. · Recording is only possible on deck 1. [. . . ] Adequate ventilation with a minimum gap of 15 cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. · The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. · To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. [. . . ]