User manual PHILIPS AZ2908

[. . . ] Door ­ lift at the respective door to open cassette/ tape or cd compartment @VOLUME ­ to adjust volume level #REMOTE SENSOR (for AZ2908 model only) ­ infrared sensor for remote control $PRESET DOWN/ UP (­, +) ­ selects a preset tuner station (down, up) %BAND ­ selects waveband ^DBB ­ (Dynamic Bass Boost) activates a more vivid bass response BACK PANEL &Telescopic aerial ­ improves FM reception *Battery compartment ­ for 6 batteries, type R-20, UM1 or D-cells (Voltage selector (inside battery compartment, some versions only) ­ adjust to match the local voltage 110/220V before plugging in the set )p ­ 3. 5 mm stereo headphone socket Note: The speakers will be muted when headphones are connected to the set. ¡AC MAINS ­ inlet for mains lead REMOTE CONTROL (for AZ2908 only) 1CD ­ selects CD sound source 2y ­ switches the set off Note: When the set is switched off, the remote control cannot operate any commands. The set needs to be switched on first via the set's y button. [. . . ] ­ TU is displayed briefly and then the radio station frequency, waveband and, if programmed, a preset number are shown. (See 4) 2 Press BAND once or more to select your waveband. 3 Press and hold or § until the frequency in the display starts running. 4 Repeat steps 2-3 if necessary until you find the desired station. ⷠTo tune to a weak station, press or § briefly and repeatedly until you have found optimal reception. Reduce its length if the signal is too strong. Direct this aerial by turning the whole set. Programming radio stations You can store up to a total of 30 radio stations in the memory, manually or automatically (Autostore). 3 Press PRESET DOWN/ UP once or more to select a preset number. Note: You can erase a preset station by storing another frequency in its place. After all stations are stored, the first autostore preset station will then automatically play. ⷠPressing 9 twice TM is displayed briefly and Note: During a CD program or if shuffle/ repeat disappears. Active, searching is only possible within a track. Different play modes: SHUFFLE and REPEAT CASSETTE RECORDER You can select and change the various play modes before or during playback, and combine the modes Cassette playback with PROGRAM. 1 Press y to on , then SOURCE to select TAPE. Shuffle ­ tracks of the entire CD/ program are TM Display: shows throughout tape played in random order operation. Shuffle and repeat all ­ to repeat the entire CD/ 2 Insert a cassette and close the door. programme continuously in random order 3 Press PLAY 2 to start playback. Repeat all ­ repeats the entire CD/ program 4 To pause, press PAUSE ;. Repeat (and shuffle repeat) ­ plays the current 5 Press SEARCH 5 or 6 to fast wind the tape. The keys are automatically released at the end of a 1 To select play mode, press MODE once or more. 3 To select normal playback, press MODE repeatedly until the various modes are no longer displayed. [. . . ] Make sure there is good ventilation to prevent the set overheating. ⷠThe mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. Tape deck maintenance (See 7) To ensure quality recording and playback of the tape deck, clean parts A, B and C as shown, once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. [. . . ]