User manual PHILIPS AZ3010

[. . . ] If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A. Note: The severed plug must be disposed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: BLUE ­ "NEUTRAL" ("N") and BROWN ­ "LIVE" ("L"). [. . . ] Release when the frequency in the display starts to change. TM The radio automatically tunes to a radio station of sufficient reception. Display shows Srch during automatic tuning. (See 4) TUNER ­ For FM, pull out the telescopic aerial. Reduce its length if the signal is too strong (very close to a transmitter). ­ For MW (AM) the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. Programming radio stations You can store up to a total of 32 radio stations in the memory: 20 FM and 12 MW(AM). 1 Tune to your desired station (see Radio Reception). 2 Press PROG MODE to activate programming. (See 5) 3 Press PRESET + or ­ once or more to allocate a number from 1 to 20 for FM or 1 to 12 for MW(AM). 4 Press PROG MODE again to confirm the setting. TM Display: prog disappears, the preset number and the frequency of the preset station are shown. (See 3) 5 Repeat steps 1-4 to store other stations. · You can erase a preset station by storing another frequency in its place. CD PLAYER CD Player Display indication for CD functions ­ CD open: CD door open (See 6) ­ disc: CD inserted (See 7) ­ In stop mode: total track number and total playback time ­ During CD playback: elapsed playback time of current track and current track number ­ Pause: elapsed playback time freezes and flashes (See 8) ­ shuffle/ repeat modes: when the respective mode is activated ­ prog: when CD programme active); prog also appears briefly when you store a track (See 9) ­ no sel: programme activated but no tracks selected (See 0) ­ full: programme memory full (See !) ­ no prog: programme cancelled (See @) ­ no disc: no disc/ error in CD operation /CD-R(W) is blank or the disc is not finalized (See # + Troubleshooting) Playing a CD Selecting a different track During playback you can use or § to select a particular track. · If you have selected a track number in the stop or pause position, press 2; to start playback. · Press § once briefly for the next track, or press repeatedly until the desired track number appears in the display. · Press once briefly to return to the beginning of a current track. · Press more than once briefly for a previous track. Finding a passage within a track 1 Press and hold down or §. · The CD is played at high speed and low volume. 2 When you recognize the passage you want release or §. [. . . ] · Sudden changes in the surrounding temperature TM The display shows all your stored track numbers can cause condensation to form and the lens of in sequence. Do not attempt to clean the lens but Erasing a programme leave the set in a warm environment until the You can erase the contents of the memory by: moisture evaporates. ­ opening the CD door; · Always close the CD door to keep the CD ­ selecting TUNER source; compartment dust-free. To clean, dust the ­ pressing 9 (twice during playback or in the stop compartment with a soft dry cloth. [. . . ]