User manual PHILIPS AZ3012-00C

[. . . ] c) Product failures caused by misuse, neglect, normal wear and tear, accidental breakage, transit damage, inexpert repairs or modification by unauthorised persons, lightning strikes, vermin infestation or liquid spillage. f) Replacement of worn or used batteries, styli or other consumables. The conditions contained in this warranty card replace and override the provisions of the World-Wide Guarantee for Products sold in Australia. Philips Service Branches To contact your nearest Philips Authorised Service Centre call 1300 36 1392 from anywhere in Australia. [. . . ] Batteries (not included) Open the battery compartment and insert six batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "­" symbols inside the compartment. Batteries contain chemical substances, so they should be disposed of properly. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore: · Do not mix battery types: e. g. Only use batteries of the same type for the set. · When inserting new batteries, do not try to mix old batteries with the new ones. · Remove the batteries if the set is not to be used for a long time. Using AC Power 1 Check if the mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service centre. 2 Connect the mains lead to the AC MAINS inlet and the wall socket. The power supply is now connected and ready for use. In the rest of the world this step is 9 KHz and 50 KHz. Usually the frequency step has been preset in the factory for your area. 1 Check that the set is completely switched off. 2 To select 9KHz: Simultaneously, press STOP 9 and PRESET ­ on the set. 3 Switch the set on to TUNER and then release the controls. · To select 10KHz: Repeat steps 1-3 but in step 2, simultaneously, press STOP 9 and PRESET + on the set. TM When you tune to radio stations, the display shows tuning in either steps of 9 kHz or 10 kHz. ­ For FM, pull out the telescopic aerial. Incline and TM All preset and autostore stations will be turn the aerial. Reduce its length if the signal is too affected and you may need to reprogramme strong (very close to a transmitter). ­ For MW (AM) the set is provided with a built-in aerial so the telescopic aerial is not needed. [. . . ] 2 To return to normal playback press PROG MODE until the shuffle/ repeat modes are no longer shown. · You can also press 9 to quit the play mode. CD PLAYER Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1 In the STOP mode, press or § for your desired track. [. . . ]