User manual PHILIPS AZ6810

[. . . ] Switches the player on, starts or pauses CD play 7 . This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds @ RESUME . 5 mm headphone socket and socket to connect the player to another analogue audio input of an additional appliance, remote control socket. Notes: ­ It is normal for the batteries to become warm during recharging. [. . . ] YThe current track number and elapsed playing time are displayed. YThe time at which playback was paused starts flashing. YThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. ⷠTo remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: If there is no activity, the set will automatically switch off after a while to save energy. In-car use (connections supplied or optionally available) Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltage converter (4. 5 V DC , positive pole to the center pin) and the AY 3501 cassette car adapter. 1 Put the set on a horizontal , vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. 2 Plug the voltage converter into the cigarette lighter jack (only for 12 V car battery, negative grounding), then connect the wired end with 4. Yrepeat : The current track is played repeatedly. Repeat all shuffle yrepeat all : The entire CD is played repeatedly. YSCAN: The first 10 seconds of each of the remaining tracks are played in sequence. 2 Playback starts in the chosen mode after 2 seconds. ⷠTo return to normal playback, press MODE repeatedly until the display shows no active modes. ESP / Power Save Mode With a conventional portable CD-player you might have experienced that the music stopped e. The ELECTRONIC SKIP PROTECTION prevents loss of sound caused by light vibrations and shocks. However ESP does not prevent playback interruptions during vigorous running. It also does not protect the unit against any damage caused by dropping!YPS is displayed once ESP on ESP off Power Save ESP on This set complies with the radio interference requirements of the European Community. Programming track numbers You can store up to 30 tracks to play in a program. [. . . ] With HOLD activated, you can avoid accidental activation of other functions. HoLd is shown when you press any button. 2 To deactivate HOLD , switch the slider to OFF. Note: If you deactivate HOLD by switching the slider to RESUME, you will be activating the RESUME function. [. . . ]